Repairs for a damaged chimney in Richmond Heights
We trace chimney damage to its cause, price each repair on its own line and start only after you approve.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Chimney damage around homes in Richmond Heights
- Damp patches near the fireplace wall
- Smoke that drifts back into the room
- Cracks that look wider than before
- Old patches that keep failing
Jump to
What chimney restoration involves at your home
When to stop using the fireplace for now
Some signs mean the fireplace should rest for now. Pieces of lining in the firebox are one. Smoke escaping anywhere other than the top of the chimney is another, as is being told the flue is damaged. Keep the fireplace out of use until the chimney has been looked at.
Tell us which of these you have noticed when you book. Some of these signs point to damage inside the flue that cannot be seen from the room. We explain what we find and what must be repaired before it is safe to light a fire again.
When the leak source is still unknown
Sometimes the visit shows water getting in but not yet where. The top, the face, the roof junction and the flue each remain possible, and guessing would mean paying for work that may not stop it.
In that case, chimney leak repair is the better starting point, because its job is to isolate the entry before any component is replaced. Once the entry is found, the repair of that part is priced on its own. We explain which of the two routes fits what we saw.
When another trade is part of the job
Some chimney repairs touch work that belongs to other trades. A roofer may need to reset the covering around the chimney. An electrician may need to move a wire, and a plumbing or heating contractor may need to disconnect an appliance vent.
We tell you which parts of the job need someone else and when in the sequence they fit. The estimate lists our work and names the other trade's step, so nothing is assumed. If you already work with a roofer or contractor, we are glad to coordinate with them directly.
A flue top with nothing over it
Without a cap, rain falls straight down the flue, and leaves, twigs and animals can get in. Water that reaches the damper and the smoke chamber can rust metal and wash out mortar inside the chimney.
We check whether each flue is capped and whether the cap fits and is secure. Adding or replacing a cap is often a small job, and chimney cap replacement covers the fitting in detail. The estimate lists it separately from any damage the open flue has already caused.
Scope lines after a chimney damage inspection
- Crown crack sealing or recasting
- Rain cap refit or replacement
- Listed replacement parts for metal chimneys
- Roof access and roof covering protection
Before you approve chimney damage repairs
Can my roofer and your team work on the same chimney?
Yes, and it often helps. We agree who handles the roof covering and who handles the chimney side of the junction, so neither trade assumes the other has closed the gap.
Do you test a suspected leak with water?
When the job calls for it, we run a hose water test, wetting one area at a time while someone watches inside. It is a diagnostic step for hard-to-trace leaks, not part of every visit.
Can you finish a repair another company started?
We can assess it. We look at what was done, what remains open and whether the earlier work is sound, then price the remaining repair as its own scope for you to approve.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo