Chimney cleaning in Dania Beach, hearth and room protected
We look for blockages before brushing and remove loose material without pushing damage out of sight.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Reasons households book a flue cleaning
- Soot specks on the hearth between fires
- Smoke drifting into the room
- Leaves or twigs falling into the firebox
- A fireplace idle for a long time
Jump to
Flue cleaning and what it leaves you with
Using a cleanout opening at the flue base
Some masonry chimneys include a small cleanout door near the base of a flue. The Florida Building Code's chimney chapter calls for one at the base of each masonry flue. The exception is a fireplace flue that can be cleaned through the fireplace opening. If your chimney has one, it gives access to debris that settles at the bottom of that flue.
Tell us if you know of a small metal access door on the chimney, inside or outside the house. We open it, remove what has collected and close it firmly so it seals. A door that is rusted shut or missing its latch is recorded as a separate repair.
The workmanship warranty on cleaning work
Cleaning is work like any other, and it is backed by our workmanship warranty. The written record says what we did, and the warranty applies to that work. Keep it with your other fireplace papers.
Suppose a part we handled, such as a damper we freed or a cap we refitted, does not work as it did before. Tell us promptly, and we look at it again under the warranty. Conditions we recorded but were not asked to repair are not part of that promise, which is why the record separates them.
Where residue collects in the flue
Deposits are not spread evenly. They tend to gather where smoke cools and slows. That can be the upper part of a flue on an outside wall, the smoke chamber or a bend. Listed metal chimney instructions note that residue condenses in a relatively cool flue.
That is why the whole reachable length is brushed, not only the part visible from the firebox. When we describe the result, we say where the heaviest material was. It hints at where your flue runs coolest and where to look first next time.
Cleaning around a damper at the flue top
Some chimneys are fitted with a top-mounted damper, worked by a cable that hangs down into the fireplace. Its plate and gasket gather soot, and a dirty gasket may not seal. The cable and its bracket also need to move freely.
During a sweep we clean the plate and gasket where they can be reached and work the cable through its range. A torn gasket, a stretched cable or a weak spring is noted as a separate repair. The damper's own instructions guide what we touch.
Parts named in your sweep estimate
- Damper plate and frame cleaning
- Findings listed apart from cleaning
- Throat cleared of soot and flakes
- Glazed deposits priced as a separate item
Chimney sweep visit questions answered
Can you clean more than one fireplace on the same visit?
Yes. Tell us about each one when you book so the estimate lists every flue and opening. Each fireplace is its own line, and you choose which ones to include.
Why do you look at the flue after it is brushed?
Soot hides the surface. Once it is off, cracks, gaps and damaged parts are easier to see. That visual check is limited to what the brushes reached, and anything it raises is explained separately.
What if a repair is needed before I can use the fireplace?
We tell you directly and write it on the record. The repair gets its own estimate, and you decide when to go ahead. Until it is done, we suggest keeping the fireplace unused.
More Ways to Care for Your Fireplace
- Chimney Flashing RepairRepair the chimney-to-roof connection with a scope that accounts for the adjoining roofing and masonry.
- Chimney RebuildRebuild the affected chimney section with the retained structure, roof connection and passage included in the plan.
- Chimney Crown RepairRepair the damaged chimney top with an approach matched to the crown and supporting masonry.
- Fireplace RestorationCoordinate fireplace repairs while preserving suitable existing features and defining the intended use.
- Wood-Burning Fireplace Insert InstallationFit a wood-burning insert after assessing its host fireplace and full connection requirements.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo