Mortar joint repair for brick chimneys in Galt Ocean Mile
If joint work alone will not fix the problem, we explain what else the chimney needs.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Mortar wear to mention when you call
- Mortar eroded back from the brick face
- Gaps opening between brick and mortar
- Earlier repointing popping out in strips
- Plants rooting in the mortar joints
Jump to
Chimney mortar repair, explained plainly
Hand chisels and the gentlest mortar removal
Federal preservation guidance describes hand chisels and mash hammers as the least damaging way to remove old mortar. The work is slower, but it poses the least risk to the brick edges. On many chimneys that care is what keeps the finished job looking right.
We use hand tools wherever the brick or the joint calls for them. On very hard mortar or wide horizontal joints, a skilled hand with a suitable tool can help. We explain the method we plan to use and how the brick edges will be protected.
Pre-wetting brick that soaks up water
Some brick absorbs water readily. Federal preservation guidance suggests misting very absorbent masonry for a period before repointing begins. Otherwise the brick pulls moisture from the new mortar before it can set properly.
We check how quickly your brick takes up water during the inspection. If it is thirsty, we plan pre-wetting into the work and allow time for it. You may see us misting a face before any mortar goes on, and that is part of doing the joints properly.
Matching the existing joint profile
Brick industry maintenance guidance says the last layer of repointing mortar should be tooled to match the original profile. A chimney repointed with a different joint shape can look patched even when the color is right.
We look for places where the original profile survives, often in sheltered spots near the crown overhang or at the roofline. We then choose a jointer that reproduces it. If the original profile is one that holds water, we raise that before matching it, so you can decide with the facts.
Joint findings explained on site in Galt Ocean Mile
At the end of a joint inspection in Galt Ocean Mile, we walk you through the results before we leave. We show which faces need work, which joints tested soft under the scraper and what seems to be wearing them down.
Stand where you can see the chimney and we will point to the areas. Nothing is too small to ask about. The written estimate that follows lists the same findings area by area, so what you heard in the yard and what you read later agree.
Mortar joint checks for homes in Galt Ocean Mile
- Water source notes before joint work
- Joint dampening before new mortar
- Curing care for the new joints
- Workmanship warranty on the agreed joints
Repointing answers for Galt Ocean Mile
How deep are the old joints raked out?
Deep enough to reach sound mortar, to an even depth that relates to the joint width, as brick industry guidance describes. Shallow raking leaves new mortar too thin to hold, which is one reason earlier repointing sometimes falls out.
Can you repoint a chimney that has stucco over the brick?
Stucco hides the joints, so there is nothing to repoint from outside. Cracked or loose stucco belongs to stucco repair. If bare brick shows above the roofline, we can assess those joints as a separate area.
How does the 72-hour window work on repointing?
If you approve the repointing, or anything else on the estimate, before 72 hours have gone by since your free inspection, we take 10% off. The clock starts at your own visit.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo