Chimney repointing and mortar repair across Lake Estates
New joints are tooled to shed water and kept damp while the mortar cures.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When chimney joints start to give way
- Gaps opening between brick and mortar
- White deposits that keep coming back
- Loose brick where joints have washed out
- Water inside after rain on one side
Jump to
What good tuckpointing looks like
Thin mortar smeared over old joints
Some quick repairs spread a thin coat of mortar across the joints without removing anything. From a distance the chimney looks renewed. Up close, a skin of new mortar sits over the old, with nothing underneath to hold it.
That skin cracks and flakes, and water gets between the layers. We identify smeared work during the inspection. Proper repointing means removing it along with the failed mortar beneath, so the new joints go into sound depth. The estimate explains the extra removal involved.
Repointing every joint in an affected area
It is hard to tell exactly which joints let water in. Brick industry maintenance guidance therefore suggests repointing all the joints in the affected area rather than picking out single joints. A joint that looks sound beside failed ones may be next.
We mark the affected area and explain where its boundary falls. The boundary usually follows the damage and the way water moves across that face. Joints well outside it stay untouched. You see the marked area before approving, so the extent does not come as a surprise.
Joints that reopen in the same place
A joint that cracks again soon after repointing has a cause worth finding. The mortar may have been too hard, the joint too shallow, or the wall may still be moving or getting wet in that spot.
We look at the pattern before repeating any repair. A single line of repeated cracking can point to movement. Scattered failures near the top can point to water from above. We explain which pattern your chimney shows and what should be addressed before those joints are renewed again.
Details to share before a tuckpointing visit
A few details help us plan. Tell us which side of the chimney looks worst, whether you have seen grit or mortar pieces and whether water shows inside after rain. Mention any earlier repointing or coatings you know about.
Describe how the roof can be reached and whether an appliance vents into the chimney. You do not need exact answers. A rough history points us to the right faces and saves time during the free inspection. Anything you remember about past repairs is useful.
Mortar joint checks for homes in Lake Estates
- Raking to an even, sound depth
- Joint profile that sheds water
- Protection for windows, roof and plantings
- Written record of faces and joints renewed
Tuckpointing questions from homes in Lake Estates
How deep are the old joints raked out?
Deep enough to reach sound mortar, to an even depth that relates to the joint width, as brick industry guidance describes. Shallow raking leaves new mortar too thin to hold, which is one reason earlier repointing sometimes falls out.
Can I use the fireplace while the chimney is being repointed?
The work is on the outside of the masonry, but fresh joints are still curing. We tell you whether a fire is fine during the project and when normal use can resume, based on where we worked and the mortar used.
Can you match a joint profile that has worn away?
We look for sheltered spots where the original profile survives, such as under the crown overhang. Where brick edges are worn, the new joint may sit slightly back from the face to avoid a thin, fragile edge.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo