Tuckpointing the chimney on your home in Lake Ridge
Chimney tuckpointing in Lake Ridge begins with a free inspection of every face of the stack.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs the chimney joints need repointing
- Joints that crumble when scraped
- Sandy grit at the base of the chimney
- Small holes and voids in the joints
- Water inside after rain on one side
Jump to
Chimney mortar repair, explained plainly
A clean, square cut behind each joint
How a joint is cut out matters as much as how deep it goes. Federal preservation guidance asks for old mortar to come away cleanly, with the back of each cut left square rather than rounded. A rounded or V-shaped cavity gives new mortar less to grip.
We clear each joint so the new mortar meets clean brick surfaces on both sides. That is slower than running a tool down the middle of the joint. It is also what lets the repointed mortar lock into place instead of sitting in a shallow groove.
Pre-wetting brick that soaks up water
Some brick absorbs water readily. Federal preservation guidance suggests misting very absorbent masonry for a period before repointing begins. Otherwise the brick pulls moisture from the new mortar before it can set properly.
We check how quickly your brick takes up water during the inspection. If it is thirsty, we plan pre-wetting into the work and allow time for it. You may see us misting a face before any mortar goes on, and that is part of doing the joints properly.
Matching color on a partly repointed face
When only part of a chimney face is repointed, the new joints sit right beside old ones. Brick industry guidance says partial repointing should match the existing mortar color, using pigment where needed.
We compare samples against the existing joints wet and dry, and we match to the less weathered mortar in sheltered spots. Where the boundary between new and old would be obvious, we may suggest ending it at a natural break, such as a corner or the roofline.
Chimney tuckpointing for homes in Lake Ridge
Chimney tuckpointing for homes in Lake Ridge follows the same order on every job. We look for the water source, test the joints, choose a mortar that suits the brick and mark the areas that need work. You see all of that before any raking starts.
The work itself is careful and unhurried. Joints are raked to sound depth, filled in layers and tooled to shed water. When we finish, the old mortar is gone, the chimney is clean and you have a written record of the areas we renewed.
What the free joint inspection covers
- Joint survey on every chimney face
- Dust cleared from the raked joints
- Joint dampening before new mortar
- Separate lines for crown or flashing work
What people ask about chimney mortar
What happens if you find damaged bricks while raking?
We stop and show you. A brick with a broken or flaking face cannot be fixed by the mortar around it. Replacing it is a separate item with its own price, and it is added only with your approval.
Can repointing be done safely on a hot day?
Yes, with care. Mortar that dries too fast bonds poorly, so we keep joints damp and shaded and may start earlier in the day. We plan around the conditions rather than rushing mortar onto a hot wall.
What details help when I call about chimney mortar?
Tell us which side of the chimney looks worst, whether grit or mortar pieces have fallen and whether water shows inside. Mention earlier repointing or coatings. These details help us plan where to look first.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo