Chimney mortar repair done joint by joint in Palm Grove
Head joints are cleared by hand, the method least likely to chip the brick edges beside them.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Mortar wear to mention when you call
- Plants rooting in the mortar joints
- Mortar pieces on the roof around the stack
- Stepped cracks following the mortar lines
- Dark wet patches that linger on the brick
Jump to
Mortar joint work behind a drier chimney
Pre-wetting brick that soaks up water
Some brick absorbs water readily. Federal preservation guidance suggests misting very absorbent masonry for a period before repointing begins. Otherwise the brick pulls moisture from the new mortar before it can set properly.
We check how quickly your brick takes up water during the inspection. If it is thirsty, we plan pre-wetting into the work and allow time for it. You may see us misting a face before any mortar goes on, and that is part of doing the joints properly.
Dust and noise while old mortar comes out
Federal preservation guidance is frank that joint preparation is noisy and can make a lot of dust. On a house, that means planning around windows, air intakes, vehicles and outdoor furniture near the chimney.
We agree with you which windows stay closed and where covers go before raking starts. Dust is controlled as the work proceeds and cleaned up at the end of each day. Tell us about anyone at home who is sensitive to dust, so we can plan the noisiest work accordingly.
Lime-rich mortar and fine hairline cracks
Mortar with a high lime content behaves differently from dense cement mortar. Federal preservation guidance notes that lime mortar is soft and porous and can re-seal fine hairline cracks as it ages. It also needs careful curing, because it hardens slowly.
Whether a lime-rich mix suits your chimney depends on the brick and the original mortar. We explain the choice and the curing care it would need. If a cement-lime mix is more suitable, we explain that instead, while keeping the mortar softer than the brick.
Wall temperature and fresh mortar
Fresh mortar needs water to cure, and the wall temperature affects how fast it loses that water. Federal preservation guidance gives a working range and warns against conditions that dry mortar too quickly.
We check the conditions on the day and plan the work around them. On a hot wall that may mean shade, misting and an earlier start. If conditions are outside what the mortar can handle, we reschedule rather than risk joints that never bond properly. We call you as early as we can when that happens.
What we check before quoting repointing
- Pre-hydrated mortar placed in thin layers
- Aftercare notes for the fresh joints
- Written record of faces and joints renewed
- Upfront price for each repointing area
What people ask about chimney mortar
How long does new mortar take to cure?
Mortar hardens gradually and keeps gaining strength after it looks set. We keep new joints damp and shaded as needed and tell you what to avoid while it cures, such as washing the brick or using cleaners on it.
Does the workmanship warranty cover tuckpointing in Palm Grove?
Yes. The joints we renew under the agreed scope carry our workmanship warranty. The written record lists the faces and areas repointed, which helps if you notice anything about the chimney later on.
Can you match a joint profile that has worn away?
We look for sheltered spots where the original profile survives, such as under the crown overhang. Where brick edges are worn, the new joint may sit slightly back from the face to avoid a thin, fragile edge.
More Ways to Care for Your Fireplace
- Chimney Flue RepairAssess repairs to damaged existing flue linings and distinguish them from a new liner installation.
- Hurricane and Storm Damage Chimney RepairAssess storm-related chimney concerns and distinguish temporary protection from permanent component repair.
- Chimney Chase Cover ReplacementReplace the chase top with a properly planned cover and clearly defined pipe connections.
- Gas Fireplace InstallationCreate a complete gas fireplace installation plan for the room, appliance and connected systems.
- Chimney Crown RepairRepair the damaged chimney top with an approach matched to the crown and supporting masonry.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo