Chimney waterproofing, planned around your brick, in Coral Terrace
Our family team tells you plainly whether the chimney needs a repellent, repairs, both or nothing yet.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Marks of water soaking into chimney brick
- Brick that stays dark long after rain
- Damp patch on the chimney breast indoors
- Uneven color across repaired sections
- Water beading on one face but not another
Jump to
What goes into treating chimney brick
Nothing below ground level
Product data for penetrating repellents usually rules out surfaces below ground. Masonry in the soil stays wet, and a repellent there cannot do its job. On an outside chimney that runs down to the ground, the treatment stops above grade.
We check how the base of the chimney meets the ground. Soil or mulch piled against the brick keeps it wet and should be pulled back. Splash from bare ground can soak the lowest courses too. Those are simple fixes, and they matter more at the base than any coating would.
Stains from rust or copper
Rust from a cap or old flashing, or green runoff from copper, can stain the brick below. A repellent applied over those stains may make them harder to remove later, because treated masonry holds stains differently.
We clean stains before treatment where the masonry allows it, using methods suited to the stain and the brick. The source of the staining is noted, because a rusting cap will keep staining the new work. If the metal needs attention, that is its own item.
Faces that stay dark after rain
Before any treatment, the way a chimney dries after rain tells us a lot. Faces that stay dark for a long time are absorbing more water than the rest. That may be the face that takes the weather, or it may be porous brick or open joints.
If you can, look at the chimney a few hours after rain and note which faces stay dark. Tell us when you book. It helps us decide which faces need treatment and where to look for repairs first.
Seeing the product on the day
Each estimate we write in Coral Terrace names the product we plan to use. On the application day, the containers are there for you to see, with their labels. If you would like a copy of the maker's data sheet, ask and we will point you to it.
That way you can confirm the product matches what you approved. If for any reason a different product is needed, such as a supply problem, we tell you before using it and explain why the substitute suits your chimney. It is your decision whether to go ahead.
Your free waterproofing inspection covers
- Cap or open flue noted at the top
- Cleaning method matched to the masonry
- Roofing and metal parts covered
- Rain-free period after application
What people ask before sealing a chimney
Is there a charge for the waterproofing inspection?
No. The inspection and the written estimate that follows are free. You pay only for work you approve, at the figure in the estimate. Any change after a test area comes to you as a separate item before it goes ahead.
Will you protect my windows and plants during application?
Yes. Repellents can haze glass and harm plants, so windows, skylights, roofing and metal near the chimney are masked and beds below are covered. We ask you to move cars and outdoor furniture. Overspray is cleaned within the time the product allows.
How long does chimney waterproofing take from start to finish?
It depends on the repairs needed first, the curing and drying time and the weather. The application itself is usually the shortest step. The estimate sets out the stages in order, and a dry weather window decides the final date.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo