Firebrick replacement for masonry fireplaces in Palmetto Bay
The chamber that takes the fire is repaired with materials that can take it, joint by joint.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Firebox problems to mention when you call
- Corner joints opening
- Rust streaks on the upper back wall
- A loose ash dump frame
- Stepped cracks climbing a side wall
Jump to
Keeping a firebox lining sound in Palmetto Bay
Deep voids behind the joints are filled in layers
Some joints lose mortar well below the surface. Refractory mortar makers note that deep cracks and joints should be filled in layers, letting each layer set before the next. One thick fill can shrink and pull away.
Where a void runs deeper still, a castable refractory product may be the better material. We look at the depth before choosing, and the estimate names the product and the method. That keeps a quick surface repair from hiding a hollow joint that will fail at the next hot fire.
Drawing the edge of the repair area
A local repair needs a clear edge. We look for where sound units and joints begin and set the repair boundary there, rather than stopping at the last visibly cracked brick.
Stopping short leaves a weak strip that fails next, while going too far replaces sound lining for no reason. The estimate describes the boundary in plain terms, such as the lower half of the back wall. That way you know exactly what will change, and what will be left as it is because it is still sound.
Pieces of clay tile in the firebox
Curved or flat pieces of fired clay on the firebox floor are often fragments of flue tile from high in the chimney. They do not come from the firebox lining.
Keep any pieces you find and show them to us. We confirm where they came from and route the flue to the service that inspects and repairs it. The firebox itself is checked for any damage the falling pieces caused, and that is listed separately. Falling tile is a sign to keep fires out until the flue has been checked.
The inspection discount for firebox repair in Palmetto Bay
After your free inspection in Palmetto Bay, firebox repairs you book within 72 hours carry a 10% discount. The window starts from your own inspection date. The discount covers the firebox lines you approve in that time.
Use the time to read the estimate and compare a local repair with a rebuild if both are offered. If you decide later, the written price still applies without the discount. Either way, nothing starts until you approve the scope. Ask us to mark the lines the discount applies to if you plan to approve only part of the work.
Materials and steps in a firebrick repair
- Each wall and the floor checked
- Thin, full joints matching the lining
- Room and hearth protection
- Curing steps written down
Questions about firebrick and mortar
What mortar goes between the firebricks?
A refractory mortar made for firebrick joints. The residential code calls for medium-duty refractory mortar in a firebrick lining, laid in thin joints. We name the exact product on the estimate and follow its directions.
Why did an earlier firebox patch fall out?
Usually because the material was not refractory mortar, the joint was not cleaned to sound material, or the repair was not heat cured. We identify what was used and remove it before repairing, so the new work bonds properly.
What happens to the damper during a firebox rebuild?
The damper frame often rests on the top of the firebox walls, so a rebuild near the top keeps it supported and resets it in its bed. If the damper plate itself is damaged, that repair is listed separately.
More Ways to Care for Your Fireplace
- Fireplace Hearth RepairRepair the hearth surface after considering the supporting assembly and fireplace requirements.
- Chimney RebuildRebuild the affected chimney section with the retained structure, roof connection and passage included in the plan.
- Gas Fireplace InstallationCreate a complete gas fireplace installation plan for the room, appliance and connected systems.
- Ventless Gas Fireplace ServiceService the identified vent-free appliance without bypassing its required safety components.
- Chimney Flue RepairAssess repairs to damaged existing flue linings and distinguish them from a new liner installation.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo