Cracked firebrick replaced in Shorecrest fireplaces
Your firebox gets firebrick and mortar made for the heat, set in the pattern the chamber was built with.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What cracked or loose firebrick looks like
- Firebrick pieces on the firebox floor
- Open joints between firebricks
- Crumbling faces on the back wall
- Backing masonry showing through a gap
Jump to
Firebox rebuilds and repointing explained
How we examine the firebox walls and floor
We look at each wall and the floor in turn. Joints are checked for loss and softness, bricks for cracks, looseness and surface loss. The top courses near the damper and the edges at the opening get extra attention.
We note the lining type, the pattern and the likely cause of what we see. Anything we cannot judge from inside the firebox, such as the backup wall, is named as a limit. The findings are explained on site before any estimate is written.
Drawing the edge of the repair area
A local repair needs a clear edge. We look for where sound units and joints begin and set the repair boundary there, rather than stopping at the last visibly cracked brick.
Stopping short leaves a weak strip that fails next, while going too far replaces sound lining for no reason. The estimate describes the boundary in plain terms, such as the lower half of the back wall. That way you know exactly what will change, and what will be left as it is because it is still sound.
The inspection discount on firebox work
Firebox repairs booked within 72 hours of your free inspection get 10% off. The time runs from your own inspection, so you have a few days to read the estimate and ask about it.
If you need longer, the estimate still holds at its written price. We would rather you choose between a local repair and a rebuild with care than rush the decision. Ask which lines the discount would cover if you are approving part of the work. The discount applies to the lines you approve in that time, whether that is one wall or the whole lining.
Dust and debris from firebox work
Cutting out firebrick and old mortar makes dust and rubble. Before starting, we cover the hearth, the floor and nearby furniture, and we set up so dust stays in and near the opening.
Old brick, mortar and packaging leave with us; debris is cleaned up and hauled away. Should the work open the chimney at the throat, we cover that opening before leaving each work day. We sweep the firebox and hearth at the end so you see the finished lining clearly.
Mortar, brick and curing on the estimate
- Earlier unsuitable patches removed
- Mortar cleaned from brick faces
- Old brick and mortar hauled away
- Return-to-use guidance
Before you book a firebox repair
How do I know if my firebox has firebrick or panels?
Firebrick shows real joints between separate units. Panels are larger pieces, often with a brick pattern molded in, and usually sit in factory-built units. We confirm the lining on the visit, because each type follows a different repair route.
How does the discount after the free inspection apply to firebox work?
Firebox lines you book within 72 hours of your free inspection get 10% off. The window counts from your own inspection. After that, the written estimate price still applies without the discount.
How should I prepare the firebox before you arrive?
Let it go cold, remove cold ashes into a covered metal container kept outside, and leave loose pieces where they fell. Clear the hearth so we can kneel and work, and set out any manual or note of earlier repairs.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo