
Your masonry fireplace, fitted with a wood insert in Allapattah
We clean and check the chimney before the liner goes in, and any repairs come first as their own items.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a wood insert starts to make sense in Allapattah
- A masonry fireplace sitting unused
- A worn insert with a warped door
- A fireplace you want closed up neatly
- A liner that stops short of the top
Jump to
Insert, liner and hearth, planned together in Allapattah
The glass and gasket are listed parts
The glass in an insert door is a ceramic glass made to withstand the unit's heat. Manuals say to replace broken glass only with the maker's specified part, and to keep the door gasket in good condition so the door seals. Ordinary glass cannot take the temperature.
We explain how to care for the glass and when the gasket needs attention. If the door latch loosens as the gasket compresses, the manual describes how it can be adjusted. Replacement parts come from the parts list for your model.
Working at the chimney top
The liner is usually lowered into the chimney from the top, so roof access is part of every insert installation with a new liner. Roof pitch, height and covering all affect how that access is set up. We plan it before the day of the work.
Tell us about any recent roof work, fragile roof coverings or access limits when you book. We explain where ladders and equipment will go and how the roof is protected. If the top of the masonry chimney needs repair, that is a separate item handled first.
The 24/7 line after the insert is in
Questions about an insert can come up on a cold evening rather than during office hours. Miami Chimney Repair keeps a 24/7 emergency line for urgent chimney and fireplace problems. Routine questions can wait for a regular call and a maintenance visit.
Keep the manual and your written record near the insert, so the model and serial number are ready when you call. Describe what you see, what you have already tried and when it started. That information helps decide the right next step.
Measuring the chimney for the liner
The liner has to run the full height from the insert collar to the chimney top. We measure that height from the top and check for offsets in the flue that a flexible liner has to follow. The measurement sets the liner length ordered.
A flexible liner can follow gentle bends in a masonry flue, provided the flue is large enough along its whole length. Where a section is too tight, we explain the options before anything is ordered. The liner length and route are recorded in your written record.
The insert installation scope, line by line
- Opening height, width and depth measured
- Top plate and liner cap
- Air control and blower walkthrough
- No link to other flues or ductwork
What people ask about wood-burning inserts
Should I buy the insert before you look at the fireplace?
It is safer to wait. The opening size, the hearth, the clearances and the liner all depend on the model, and measurements often rule some out. We check the models you like against your fireplace first.
Can the insert connect to my home's air conditioning ducts?
No. Insert manuals warn against connecting to any air distribution ductwork unless the manual approves it specifically. The insert heats the room it sits in, and its flue gases go only up the liner.
Why does the new insert smell during its early fires?
The high-temperature paint cures during the break-in fires and gives off an odor, which manuals describe as expected. Keep those fires moderate, ventilate the room and set nothing on top of the insert until the curing is done.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo

