Insert installation for masonry fireplaces in Imperial Point
Choosing an insert starts with the opening you have, measured in height, width and depth, not only across the front.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs your fireplace is ready for a wood insert
- A masonry fireplace sitting unused
- Soot on the face above the opening
- A liner that stops short of the top
- Mortar gaps inside the firebox
Jump to
Installing a wood insert the way its manual intends
Check the insert's permitted flue connection
The selected insert and liner instructions determine the permitted flue connection. The DuraLiner system cited here calls for a dedicated liner, while other systems must be checked against their own listings and manuals. An unsuitable shared flue can send smoke or combustion gases into a room.
If your chimney has more than one flue, we identify which one serves the fireplace. If another appliance already uses the fireplace flue, we explain the conflict before any work is planned. The written record notes which flue the insert uses.
Signs of overfiring in an insert
Manuals warn that if the body of the insert, the chimney connector or the baffle begins to glow, the unit is overfiring. The advice is to stop adding fuel and close the air control until the glow subsides. Overfiring can warp steel and void the warranty.
We explain what a normal fire looks like in your insert and what counts as too much. Large loads of small, very dry wood with the air wide open are a common route to overfiring. If you see the signs, follow the manual and ask us to check the unit afterward.
Smoke and carbon monoxide detection near the insert
Insert manuals recommend working smoke and carbon monoxide detection in the home, especially near bedrooms, and one suggests detection in the same room as the insert. Placement matters, because a detector right beside the loading door can sound whenever the door opens.
We mention detection at handover because an insert changes how the room is used. A fire extinguisher kept where everyone in the household knows to find it is also recommended. None of this replaces the manual's safety section, which is worth reading in full.
The cap at the top of the liner
The cap on a relined chimney covers the liner outlet and keeps rain, leaves and animals out. It comes from the liner system and fits the top plate or liner as the instructions show. A missing or damaged cap lets debris fall toward the insert.
We check the cap during maintenance and after any smoke complaint. If it is loose, bent or blocked, we explain the fix and use the part the liner system lists. The cap is also where birds and nesting material tend to show up first.
Confirmed before a wood insert is ordered
- Metal tag fixed to the fireplace
- Noncombustible hearth extension check
- Daily cover for the open chimney top
- No link to other flues or ductwork
Wood insert questions from homes in Imperial Point
Why does the new insert smell during its early fires?
The high-temperature paint cures during the break-in fires and gives off an odor, which manuals describe as expected. Keep those fires moderate, ventilate the room and set nothing on top of the insert until the curing is done.
What if my chimney already has a liner from an older insert?
We check whether the existing liner matches the new insert's size, runs the full height and belongs to a listed system in good condition. If it does, we explain that option. If not, a new liner is listed as a separate item.
How close can furniture sit to a wood insert?
The manual for your model sets the clearances and the protected floor area, and furniture belongs outside them. We point out those zones at handover. Keep rugs, cushions and stored wood out of the area in front of the loading door.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo