Insert installation for masonry fireplaces in Olympia Heights
Fireplace insert installation for homes in Olympia Heights, planned around the host fireplace and the insert's own manual.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Reasons to consider a wood insert for your fireplace
- Little warmth from an open fire
- Soot on the face above the opening
- A liner that stops short of the top
- An old insert without its manual
Jump to
Installing a wood insert the way its manual intends
Liner size comes from the insert manual
The liner diameter is not a matter of preference. Liner instructions say it must be no smaller than the size the appliance maker specifies, and the insert manual gives that size. A mismatched liner can upset the draft the insert was designed around.
We confirm the collar size on the insert you choose and match the liner to it. If your masonry flue is too tight for the required liner, we explain the options before anything is ordered. The size is written into the estimate so it can be checked.
Getting to know the insert's air control
Most inserts have a primary air control that sets how fast the fire burns. Opening it gives a hotter, faster fire, and closing it slows the burn. Manuals describe starting with the air fully open, then adjusting once the fire is established.
We show you the control on your insert and how it relates to the settings the manual describes. We also explain the manual's warnings about turning the air down too far, too soon. A steady, well-managed fire burns cleaner and keeps the glass clearer.
Signs of overfiring in an insert
Manuals warn that if the body of the insert, the chimney connector or the baffle begins to glow, the unit is overfiring. The advice is to stop adding fuel and close the air control until the glow subsides. Overfiring can warp steel and void the warranty.
We explain what a normal fire looks like in your insert and what counts as too much. Large loads of small, very dry wood with the air wide open are a common route to overfiring. If you see the signs, follow the manual and ask us to check the unit afterward.
Sounds a new insert makes as it heats
Metal expands as it heats and contracts as it cools, so a new insert can make cracking and popping sounds as it warms up. Manuals describe these noises as normal and say they become minimal once the unit reaches temperature. They are different from the roaring of an overfired unit.
We explain which sounds to expect and which ones deserve a call. Loud, persistent roaring with glowing metal is a warning sign, while ticking during warm-up is not. If you are unsure what you are hearing, describe it to us and we can advise.
Confirmed before a wood insert is ordered
- Host fireplace condition check
- Mantel and trim clearance check
- No link to other flues or ductwork
- Manual and listing details handed over
Fireplace insert questions we hear in Olympia Heights
Can I use my old fireplace grate inside the insert?
Many insert manuals say not to use a grate or andirons and to build the fire directly on the firebrick floor. We remove any old grate before installation and show you how the manual wants the wood arranged.
How is the discount for booking quickly applied?
If the insert and liner are approved while fewer than 72 hours have passed since your free inspection, 10% comes off what you agreed. Nothing about the discount asks you to decide before we have looked at the fireplace, since the clock begins at your own inspection.
What does the free inspection include for an insert in Olympia Heights?
We look at the masonry fireplace, the smoke chamber, the damper, the chimney and flue, the hearth and the trim around the opening. We also check roof access for the liner work and measure the opening in three directions.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo