Factory-built or masonry fireplaces, installed in Bay Point
We explain each decision before you approve it, from the model and hearth to the chimney termination.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Reasons people plan a fireplace installation in Bay Point
- A room with no fireplace yet
- Discontinued model with no listed parts
- Cracked panels in a worn-out unit
- A masonry fireplace you want built new
Jump to
Fireplace installation work, explained in plain terms
Factory-built unit or site-built masonry fireplace
A new wood-burning fireplace takes one of two forms. A factory-built unit arrives as a metal firebox tested with its own chimney sections, then gets framed into the wall. A masonry fireplace is laid on site, from a footing up through the firebox, smoke chamber and chimney.
Each form answers to a different rulebook. The factory-built unit follows its listing and manual, while masonry follows the Florida Building Code's fireplace section. We explain which one suits your room and structure before a single part is ordered.
Exhaust fans can compete with a fireplace
A wood fire needs air coming into the room to replace what goes up the chimney. Kitchen hoods, bathroom fans and clothes dryers push air out of the house at the same time. When they run together, the fireplace can lose that contest and spill smoke.
Tell us which exhaust fans the house has and where they are. We explain how the outside air supply and the manual's guidance on house pressure apply to your layout. Starting the fire with the strongest fans off is advice we repeat at handover.
Hearth and hearth extension in masonry
A masonry fireplace sits on a hearth of concrete or masonry, with a hearth extension reaching into the room. Both rest on noncombustible supports and are reinforced to carry their own weight. The code does not allow combustible forms to stay beneath them after construction.
We explain how the hearth will be supported on your floor structure and how the forms come out afterward. The hearth surface can take the stone or tile you choose, provided it meets the code. The support and the finish appear as separate items.
Planning for a gas appliance later needs the listing
Some owners plan a wood fireplace now and a gas appliance in it later. An unvented gas log heater may sit in a factory-built fireplace only if the fireplace was tested and listed for it, according to the code. Vented gas products also need the maker's approval for that unit.
If you might convert later, tell us now so we can check the listing of the unit you choose. Gas work belongs to separate services, and nothing gas-related is part of this installation. Knowing the plan today keeps the option open instead of closing it by accident.
Scope lines for installing a wood fireplace
- Floor, ceiling and attic framing check
- Chase framing for an exterior chimney
- Exhaust fans and house pressure review
- Grate, screen and supplied accessories check
Installing a fireplace in Bay Point, your questions
What happens to the roof opening at the end of each day?
Any open roof penetration is covered at the end of every work day until the chimney is sealed. Debris is gathered daily and taken away with us once the job is complete. Tell us about anything else on the roof we should protect.
Do you set the tile or stone around the opening?
Only if the estimate names it. Often the finish belongs to a tile setter or mason. Either way, we mark the noncombustible zones and the mantel limit so whoever sets the finish works to the manual.
Does a new wood fireplace need a damper?
A masonry fireplace must have a ferrous metal damper operable from the room, under the code. A factory-built unit includes the damper its maker designed. Either way, the damper stays fully open while a fire burns.
More Ways to Care for Your Fireplace
- Chimney Chase Cover ReplacementReplace the chase top with a properly planned cover and clearly defined pipe connections.
- Gas Fireplace VentingAssess and repair the gas fireplace vent arrangement using components suited to the identified system.
- Spalling Brick Repair and Chimney Brick ReplacementReplace deteriorated chimney bricks while retaining suitable surrounding masonry.
- Wood-Burning Fireplace Insert InstallationFit a wood-burning insert after assessing its host fireplace and full connection requirements.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo