Factory-built or masonry fireplaces, installed in Coral Gate
Tell us the room and how you want to use the fire. We explain which kind of fireplace can work there.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Starting points for installing a wood fireplace in Coral Gate
- A prefab unit with a warped firebox
- Smoke rolling out of an old unit
- A blank wall where a fire belongs
- An old unit that fails its listing
Jump to
Before, during and after your fireplace installation
Factory-built unit or site-built masonry fireplace
A new wood-burning fireplace takes one of two forms. A factory-built unit arrives as a metal firebox tested with its own chimney sections, then gets framed into the wall. A masonry fireplace is laid on site, from a footing up through the firebox, smoke chamber and chimney.
Each form answers to a different rulebook. The factory-built unit follows its listing and manual, while masonry follows the Florida Building Code's fireplace section. We explain which one suits your room and structure before a single part is ordered.
Air returns and attic ducts near the chimney
Manuals ask that return grilles for heating and cooling not sit right next to the fireplace. A strong return can tug at the opening and upset the draft. They also list sealed joints on attic ductwork and air handlers among the conditions for good performance.
We note returns and attic duct runs close to the proposed location. If one sits too close, moving it belongs to your air conditioning contractor, and we list it as coordination rather than our own work. You decide whether to adjust the plan or the return.
Fitting a new unit into an old enclosure
A replacement unit rarely has exactly the framing dimensions of the one it replaces. The new manual may need a taller opening, a deeper enclosure or a different header position. Forcing a unit into a tight space closes the air spaces it depends on.
We measure the existing enclosure against the manual of each unit you are considering. Some fit with small framing changes, while others need a rebuilt enclosure. The estimate shows which is which, so you can weigh the unit against the carpentry it brings.
An old hearth may not suit the new unit
The hearth extension in front of an old unit was sized for that unit's listing. A replacement may need a larger extension, different thermal protection underneath or a different height. Keeping the old hearth only works when the new manual agrees with it.
We check the existing hearth against the new requirements during the free inspection. If it falls short, we explain whether it can be extended or must be rebuilt. Tile matching is hard to promise, so we discuss the finished look honestly before you approve.
The installation checklist behind your estimate in Coral Gate
- Decorative shroud limits under the listing
- Noncombustible board and face materials
- Removal of a failed prefab unit
- Masonry chimney lining and cleanout plan
Questions about installing a new fireplace in Coral Gate
How is the size of the hearth extension decided?
For a factory-built unit, its manual sets the size, material and any protection beneath it. For masonry, the code ties the extension to the size of the opening. We outline it on your floor during planning so you can see its reach.
Why does a brand new fireplace smell during early fires?
Manuals describe an industrial odor while oils and binders burn off and the paint cures. It is expected during the break-in fires. Ventilate the room while it lasts, and tell us if the smell continues well beyond that period.
Where should furniture sit relative to the new fireplace?
Outside the clear space the manual prints for your model. Curtains, chairs and stored items stay back, and nothing combustible sits on the hearth extension. We point out the zone at handover so you can arrange the room.
More Ways to Care for Your Fireplace
- Chimney Animal RemovalAssess occupied chimney openings and plan appropriate follow-up cleaning or entry protection.
- Chimney Flue RepairAssess repairs to damaged existing flue linings and distinguish them from a new liner installation.
- Chimney Cap Installation and ReplacementProtect the chimney opening with a cap chosen for its fit, attachment and compatible system.
- Stone Chimney RepairRepair affected stone chimney surfaces with the supporting construction and visual match considered together.
- Chimney Crown RepairRepair the damaged chimney top with an approach matched to the crown and supporting masonry.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo