Installing a wood fireplace in Gladeview, start to finish
You receive the manual, the listing details and a written record of the work when the fireplace is handed over.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a new fireplace is the right call in Gladeview
- An exterior chase that needs a new unit
- Cracked panels in a worn-out unit
- An old unit that fails its listing
- An enclosure too small for newer units
Jump to
From listing label to first fire, the installation
How tall the finished chimney must stand
The finished chimney has to clear the roof by the amounts set in the manual and, for masonry, in the code's termination rule. Nearby parts of the building within a set distance also count. A chimney that stops short can draw poorly and send smoke back down.
We measure the roof and any higher walls near the exit before ordering chimney sections. If extra height is needed, the parts list grows and the roof view changes. We explain both effects so the chimney's height does not surprise you when the job is finished.
Cleaning access planned into a masonry chimney
Masonry chimneys need a way to remove fallen soot from the bottom of every flue, and the code names a cleanout door with a noncombustible cover for that. Fireplace flues are exempt where cleaning can happen through the fireplace opening. The design has to make that access real, not assumed.
We explain how your future chimney will be swept and from where. If the smoke chamber or flue layout would block cleaning through the opening, a proper cleanout goes into the plan. Designing for maintenance now keeps later visits simple and thorough.
Nothing is built before you approve the scope
Approval comes before work. After the free inspection, you receive a written estimate that names the model, the route and every item we propose. Read it, ask about anything unclear and decide at your own pace.
Changes to the plan after approval are written down and approved again before they happen. No framing is cut and no part is ordered until you sign off. That order protects you from paying for work you did not choose, and it keeps the job predictable for both sides.
Fireplace doors fully open or fully closed
On fireplaces that have doors, manuals say to run the fire with the doors fully open or fully closed, not halfway. Doors left partly open can draw flame and gases out of the opening. Some installations need a particular position to avoid smoke spillage.
We explain the door positions your manual allows and which one suits your house. If the doors came with the unit, keep their instructions with the manual. Door kits bought later are outside our scope and must be ones the maker approves.
Parts of the job your installation estimate separates
- Chimney route from firebox to roof
- Old chimney pipe removal and disposal
- Surrounding finish boundaries for other trades
- Daily cover for the open roof penetration
Common questions on masonry and prefab installation
Can the old chimney pipe stay when a prefab unit is replaced?
Usually not. The new fireplace is listed with its own chimney, and mixing it with pipe from another system breaks that listing. We check the old pipe's markings and the new manual, and explain the rare cases where the maker allows reuse.
Can the chimney run up an outside wall of the house?
Yes, inside a properly built chase. Manuals ask for the chase to be framed and sealed like an outside wall, with false ceilings and firestops as it rises. The chase, its cladding and its top are priced as separate items.
Where should furniture sit relative to the new fireplace?
Outside the clear space the manual prints for your model. Curtains, chairs and stored items stay back, and nothing combustible sits on the hearth extension. We point out the zone at handover so you can arrange the room.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo