New fireplace installation in Little Havana, framing to first fire
Book the agreed installation no later than 72 hours after your free inspection and save 10% on it.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a new fireplace is the right call in Little Havana
- A room with no fireplace yet
- A prefab unit with a warped firebox
- Old chimney pipe with separated joints
- No outside air for the fireplace
Jump to
How we plan a fireplace installation in Little Havana
Why a straight chimney path helps
Factory-built chimneys can bend around framing with listed offset sections, but the code and the manuals limit how many bends there may be and how steep they are. Each offset adds joints, supports and places where the path can go wrong. A straighter route is easier to build and to service.
We plan the route to use as few offsets as the house allows. When an obstacle forces a bend, the offset parts come from the same listed system. The estimate states how many offset sections the route needs, so you know why the parts list looks the way it does.
Air returns and attic ducts near the chimney
Manuals ask that return grilles for heating and cooling not sit right next to the fireplace. A strong return can tug at the opening and upset the draft. They also list sealed joints on attic ductwork and air handlers among the conditions for good performance.
We note returns and attic duct runs close to the proposed location. If one sits too close, moving it belongs to your air conditioning contractor, and we list it as coordination rather than our own work. You decide whether to adjust the plan or the return.
Ask what review the installation needs
Fireplace manuals tell owners to contact the local building or fire officials about restrictions and installation inspections before work begins. The requirements depend on the job and the jurisdiction, and we do not assume every installation is treated the same way.
Ask us early what review your project may need and how it fits the schedule. If an inspection is required at a rough-in stage, the walls stay open until it happens. We explain those steps rather than promising a shortcut around them.
Listed hearth extension panels
Some factory-built fireplaces accept a listed hearth extension product in place of a site-built extension. The code allows these when they are listed and used as the fireplace listing describes. They can simplify the floor work where a raised hearth is not wanted.
We check whether your chosen model allows a listed extension and which products it names. If you prefer stone or tile, the manual still controls what goes underneath it. Either route is written into the estimate so the hearth decision is clear.
The fireplace installation scope, item by item
- Removal of a failed prefab unit
- Electrical coordination for a blower kit
- Firebrick, baffle and refractory placement
- Masonry chimney lining and cleanout plan
Fireplace installation questions raised in Little Havana
How is the size of the hearth extension decided?
For a factory-built unit, its manual sets the size, material and any protection beneath it. For masonry, the code ties the extension to the size of the opening. We outline it on your floor during planning so you can see its reach.
What happens to the roof opening at the end of each day?
Any open roof penetration is covered at the end of every work day until the chimney is sealed. Debris is gathered daily and taken away with us once the job is complete. Tell us about anything else on the roof we should protect.
Do kitchen fans and bathroom fans affect a wood fireplace?
They can. Exhaust fans remove air from the house, and the fire needs air to replace what goes up the chimney. We review the fans and the outside air plan together, and at handover we explain how to start fires with the strongest fans off.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo