Masonry or prefab fireplace installation in Rock Island
An open roof penetration gets covered before we leave each day, and debris leaves the property with us.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Starting points for installing a wood fireplace in Rock Island
- Rusted metal inside an old fireplace
- Cracked panels in a worn-out unit
- An enclosure too small for newer units
- Framing too close to the old unit
Jump to
Installing a wood-burning fireplace, one decision at a time
An outside air supply for the fire
The Florida Building Code asks for an exterior air supply to fireplaces unless the room is mechanically ventilated and held at neutral or positive pressure. For a factory-built unit, the duct for outside air must be a listed component installed to the maker's instructions.
We plan the outside air path together with the chimney path. It needs its own opening through a wall or into a ventilated space, and its own termination hood. The route, the hood and the damper control appear on the estimate so you can see what the supply involves.
Steel fireplace units inside masonry
The code allows a steel fireplace unit to be encased in solid masonry to form a masonry fireplace. It can follow its own listing or the code section written for these units, which sets steel thickness and masonry cover. Some of these units circulate warmed room air through ducts.
If this hybrid appeals to you, we explain how it differs from an all-brick firebox and from a fully factory-built unit. The circulating ducts must be metal or masonry. We only propose it when the unit's instructions and the masonry plan match.
Planning for a gas appliance later needs the listing
Some owners plan a wood fireplace now and a gas appliance in it later. An unvented gas log heater may sit in a factory-built fireplace only if the fireplace was tested and listed for it, according to the code. Vented gas products also need the maker's approval for that unit.
If you might convert later, tell us now so we can check the listing of the unit you choose. Gas work belongs to separate services, and nothing gas-related is part of this installation. Knowing the plan today keeps the option open instead of closing it by accident.
If smoke drifts into the room after installation
Smoke that escapes into the room usually has a simple cause. Manuals list a damper not fully open, too little air reaching the fire, exhaust fans running, a blocked cap, wet wood and a chimney that is too short. Most of these can be checked quickly.
Start with the damper and the fans, then look at the wood you are burning. If the problem continues, stop using the fireplace and tell us. We check the draft, the cap and the air supply against the manual and explain what we find.
Installation items you approve before work begins in Rock Island
- Clearances to framing and finishes
- Noncombustible board and face materials
- Old chimney pipe removal and disposal
- Structural support for chimney sections
New fireplace questions, answered plainly
How soon can we light the new fireplace?
After the installation is complete and any required inspection is done. The early fires should be moderate so the paint and refractory can cure, as the manual explains. We go through the lighting routine with you at handover.
Why does a brand new fireplace smell during early fires?
Manuals describe an industrial odor while oils and binders burn off and the paint cures. It is expected during the break-in fires. Ventilate the room while it lasts, and tell us if the smell continues well beyond that period.
Can chimney parts from another brand be used to save money?
No. A factory-built fireplace is tested with specific chimney parts, and substituting another brand breaks its listing and can void the warranty. We use only the parts the fireplace manual names, from the firebox to the termination cap.
More Ways to Care for Your Fireplace
- Chimney Flashing RepairRepair the chimney-to-roof connection with a scope that accounts for the adjoining roofing and masonry.
- Hurricane and Storm Damage Chimney RepairAssess storm-related chimney concerns and distinguish temporary protection from permanent component repair.
- Gas Fireplace InstallationCreate a complete gas fireplace installation plan for the room, appliance and connected systems.
- Chimney Chase Cover ReplacementReplace the chase top with a properly planned cover and clearly defined pipe connections.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo