
Masonry and factory-built fireplaces repaired in Miami Beach
Pick the repairs you want, confirm them inside 72 hours of your free inspection, and save 10%.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Wood and masonry fireplace faults we trace
- Damper handle that will not move
- Grate bent or sagging
- Rust flakes on the firebox floor
- Trim scorched near the opening
Jump to
Fireplace maintenance and repair, explained
When part of the job belongs to another trade
Some fireplace repairs touch work outside our trade. A new electrical circuit for an electric unit is work for an electrician. A change to the gas supply belongs to a gas contractor. Framing or finish carpentry well beyond the fireplace may need a carpenter.
We say where our work stops and another trade's begins. The estimate lists only what we will do and names the other items so they are not forgotten. You are not paying us for work we do not perform, and nothing falls between two contractors.
Using the fireplace before the repair is done
After the inspection, ask whether the fireplace can be used until the repair. Some faults, such as a chipped face tile, do not affect use. Others, such as a loose firebox wall or a damper that will not open, mean no fires until they are fixed.
We give you a clear answer for your fireplace rather than a general rule. If it should not be used, we explain why in plain terms. A note taped to the fireplace is a simple way to make sure everyone in the house knows.
The fireplace depends on the chimney above it
A fireplace works only as well as the chimney that carries its smoke. A repair in the room does not fix a blocked or damaged flue above. We keep the two in view even when you called about the fireplace alone.
If the chimney needs attention, we say which service covers it and whether the fireplace repair should wait. Where the chimney looks fine from what we can see, we say that too. The estimate keeps fireplace items and chimney items apart so each can be decided on its own.
Keeping the fire inside the firebox
Logs that hang over the front of the grate or lean against the walls put flame where the fireplace was not built to take it. The firebox lining, the damper and the face above the opening all suffer. The maker's manual often describes how to lay the fire.
Smaller loads placed on the grate burn more cleanly and are gentler on the fireplace. If the fireplace has been run with oversize fires, tell us. It helps explain a cracked lining, heat marks on the face or a warped damper, and it shapes our advice after the repair.
Line items in a fireplace maintenance estimate
- Surround and face units
- Ash dump and cleanout doors
- Smoke shelf debris seen from below
- Limits of what was examined
Fireplace Repair answers for homes in Miami Beach
Can a factory-built unit take a part from another brand?
Not unless the listing allows it. A factory-built fireplace is tested and listed as an assembly, and the code requires it to be kept that way. We match parts to the model on the label, or explain why a match is not possible.
What does the written record of the work include?
It names the parts repaired or replaced, the materials used and anything we noticed but did not touch. Keep it with the manual. It helps later visits and any workmanship warranty question.
Should I clean the fireplace before you arrive?
Only if the ashes are fully cold, and only as far as is easy. Leave soot marks, loose pieces and any damage where they are, because they help us see what happened. A clear hearth and a clear path to it help most.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
