Masonry and factory-built fireplaces repaired in Washington Park
Pick the repairs you want, confirm them inside 72 hours of your free inspection, and save 10%.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What to describe before a fireplace fix
- Cracked tile on the hearth
- Cracks at the corners of the opening
- Gap between the face and the wall
- Cleanout door hanging open
Jump to
How fireplace repair works in Washington Park
Damper controls within reach of the room
The damper control belongs in the room with the fireplace, where you can open it before a fire and close it after one. A chain that has slipped out of reach or a handle that no longer engages leaves you guessing about the damper's position. That doubt is a reason to pause fires until it is sorted.
Ask us to show you the open and closed positions during the visit. If an earlier repair altered the control, we explain what changed and whether it still works as the code expects. Adjusting a control is usually a small item, listed apart from any damper replacement.
Hearth protection for factory-built fireplaces
A factory-built fireplace needs the hearth extension its listing calls for, and under the code that extension has to stand out clearly from the flooring around it. Some manuals also require metal hearth strips and a noncombustible seal where the extension meets the unit.
When flooring changes around the fireplace, those details can get lost. We check the extension against the manual and note what is missing. Rebuilding the extension is hearth work; here we make sure it is on the list when the fireplace itself is being repaired.
Heat marks on the mantel or the wall above
Discolored paint, blistered finish or a darkened mantel edge above a fireplace show that heat is reaching further than it should. The cause may be the size of the fires, trim sitting too close, or smoke escaping at the top of the opening.
We check the clearances around the opening against the code or the unit's manual. If the marks come from the way the fireplace is used, we explain that too. Changing trim or finishes is a separate decision, made after the cause is clear.
Comparing fireplace repair proposals
If you compare our estimate with another, check that both describe the same fireplace type, the same components and the same materials. A lower line may leave out access, protection of finishes or listed parts. A higher one may include work you do not need.
Ask each company to name what is and is not included. We are glad to go through our own lines with you. A clear comparison serves everyone better than a decision made on the bottom figure alone.
Items on a wood fireplace repair estimate
- Fireplace type and fuel confirmed
- Firebox lining condition
- Spark screen and its closure
- Optional items on separate lines
What people ask about fireplace maintenance
Can the fireplace and the chimney be handled on one visit?
They can often be booked together. Each has its own services and its own lines on the estimate, so you see what the fireplace work covers and what the chimney work covers before approving either one.
Can you look at the damper behind my gas logs?
Yes. The damper and firebox around gas logs are fireplace parts. The log manual decides the damper setting, and we check that it can be held there. Faults in the logs or their controls go to our gas services.
Why do you ask what I burn in the fireplace?
What goes into the fire affects wear. Wet wood, scrap, painted wood and liquid starters each leave their own marks on the firebox and damper. Knowing what was burned helps us read the damage and advise on use afterwards.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo