
A restored fireplace, safe and true to its look, in Doral
Safe working order comes first. The original look follows, with materials that match what is already there.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a fireplace needs restoring
- Fireplace unused for many years
- Damper that no longer moves
- Crumbling joints in the face brick
- Earlier repairs that keep failing
Jump to
A restoration plan built around your fireplace
An ash dump door in the firebox floor
An ash dump is a small hinged metal door set into the firebox floor of some masonry fireplaces. Ash swept through it drops into a chamber below. After years without use, the door can rust shut, lose its hinge or sit loose in its frame.
We check whether the door opens, closes and sits flush with the floor. A loose or broken door can let embers fall where they should not. Depending on its condition, we free, reset or replace the door, or explain the option of closing it off. The ash chamber itself is checked where it can be reached.
White deposits on the face
White, powdery deposits on masonry usually mean water has moved through it and left salts behind. Masonry guidance on these deposits says to find and correct the water source before the deposit is removed.
Inside a house, that source may be a leak higher in the chimney or a damp wall behind the fireplace. We note the deposits, look for the water and list the source as a separate item if it lies outside the fireplace. Cleaning the deposit without stopping the water would only bring it back.
Planning the length of a restoration
The length of a restoration depends on how many items it includes and on material curing times. A firebox repair and a face clean may take one visit. A fuller restoration can run over several.
We give you a realistic sequence with the estimate. Some steps have to wait for mortar to cure before the next can start. If the work runs past one day, an open flue is covered before we leave on each work day. Once the last step is done, we say when the fireplace can burn again.
Dust and noise during the work
Removing old mortar and cutting out damaged brick make noise and dust. Cleaning makes less noise but can involve water and brushes near the opening.
We protect the room, manage dust at the source and clean up as we go. If there are times when noise would be a problem, tell us and we plan the loud steps around them. When the work is done, debris is bagged and hauled away, and the area is cleaned before we leave. Tell us about anyone in the house who is sensitive to dust, so we take extra care at the opening.
Restoration work priced before it starts
- Hearth cracks and loose units repaired
- Room and floor protection
- Free written estimate before any work
- Grate size and position checked
Before you approve restoration work
Can you restore a stone fireplace face?
Yes. Loose stones are reset and open joints are repointed with a mortar suited to the stone. If a stone is broken, we look for a match and explain the options before replacing it.
Can a restoration be done in stages?
Yes. Essential safety repairs can go ahead before finish work. Each stage is priced separately, and we explain which items must happen before the fireplace is used and which can wait.
Can you tell whether my fireplace is masonry or factory-built?
Yes, during the free inspection. The difference matters, because a masonry fireplace is repaired with masonry methods while a factory-built unit must stay within its listing and use the manufacturer's parts.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo

