Brick fireplace restoration, planned as one job, in Key Biscayne
A long-idle fireplace gets a full look before any fire, then a plan to make it usable again.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a fireplace needs restoring
- Loose or missing firebrick
- Crumbling joints in the face brick
- Firebox floor worn or broken
- Water marks inside the firebox
Jump to
How we restore a neglected fireplace
Start from how you want to use the fireplace
Tell us what you want from the fireplace. Some people want regular fires again. Others want it safe for an occasional evening, or simply sound and good to look at. The goal changes which items matter most.
A fireplace that will burn often needs every fire-facing part in good order. One that will rarely burn may need the same safety items but less finish work. We write the goal at the top of the estimate, so every line below it can be read against that purpose.
Rusted metal in a factory-built firebox
The metal parts of a factory-built firebox can rust after years of damp or disuse. Surface rust may be harmless. Rust that has thinned or holed the metal is not.
We check the metal surfaces, the joints and any areas that carry heat. Where the damage is in a replaceable listed part, we order that part. Where it is in the body of the unit, we explain what that means for continued use. The manufacturer's instructions guide what can be repaired and what cannot.
Air loss through an idle fireplace
A fireplace with a damper that no longer closes lets room air leave through the flue. In a house that runs its air conditioning, that is cooled air you have already paid for.
Restoring the damper so it closes squarely reduces that loss. It will not make the fireplace airtight, because a throat damper closes metal against metal. We explain what the restored damper can achieve and whether another closure option would suit if you want a tighter seal.
Judging cleaned brick once it is dry
Wet brick looks darker than it will once dry, and it can hide a stain that is still there. Masonry cleaning guidance recommends judging a cleaned area after it has dried, not while it is still wet.
We let cleaned areas dry before deciding whether another pass is needed. That avoids over-cleaning, which can wear the brick surface. When the face is done and dry, we look at it with you. If a stain remains, we explain whether a further step is safe for the brick or whether it is better left.
Restoration work priced before it starts
- Damper freed, repaired or replaced
- Mortar cure instructions before use
- Open flue covered at the close of each day
- Grate size and position checked
Questions before restoring a fireplace
Will the new mortar match the old joints on the face?
We aim to match color, texture and joint shape. Face joints are repointed with a mortar no harder than the brick, following preservation guidance. The match is checked on a small area before the whole face is done.
Can a restoration be done in stages?
Yes. Essential safety repairs can go ahead before finish work. Each stage is priced separately, and we explain which items must happen before the fireplace is used and which can wait.
What should I mention when I call about restoration?
Tell us how long the fireplace has been idle, how you want to use it and what you want to keep. Mention past repairs if you know of any, and whether the fireplace is masonry or factory-built.
More Ways to Care for Your Fireplace
- Gas Fireplace VentingAssess and repair the gas fireplace vent arrangement using components suited to the identified system.
- Chimney Crown RepairRepair the damaged chimney top with an approach matched to the crown and supporting masonry.
- Chimney Chase Cover ReplacementReplace the chase top with a properly planned cover and clearly defined pipe connections.
- Smoke Chamber RepairRepair identified smoke-chamber surfaces with the access and material requirements clearly defined.
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo