Fireplace restoration, firebox to face, for South Miami homes
For homes in South Miami, restoration work comes with a free written estimate and no hidden fees.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Restoration needs you can spot from the room
- Patches in mismatched mortar
- Rough stepped masonry above the throat
- Water marks inside the firebox
- A face darkened by old fires
Jump to
Fireplace restoration in South Miami, planned as one job
Masonry or factory-built decides the method
A masonry fireplace is built on site in brick, block or stone, and its firebox is lined with firebrick. A factory-built fireplace is a metal unit tested and listed as an assembly. From the room, the two can look alike.
The difference decides how restoration is done. Masonry work uses heat-rated mortar, matching brick and careful repointing. A factory-built unit is restored only with the parts its manufacturer lists. We confirm which type you have during the free inspection, before any method is proposed.
Curing new mortar before the fire returns
Fresh firebox mortar needs to dry out before a fire reaches it. The makers of heat-resistant fireplace mortar publish drying and curing steps, and some ask for air drying followed by small fires.
We give you those steps in writing when the work is done. Following them protects the joints you just paid for. A large fire too soon can crack fresh mortar and open the joints again, which means the repair has to be done twice. If a cure step is unclear, ask before the fire rather than after it.
The floor of the firebox
The floor of the firebox carries the fire, the grate and the ash. It wears unevenly, cracks and sometimes loses units near the front edge where tools strike it.
We check the floor for loose, broken or sunken units and for gaps along the walls. Damaged units are replaced and set in heat-rated mortar. If the floor has settled, we look for the cause below it before resetting the surface. The floor is listed separately from the walls, so you can see its own scope.
Why metal brushes stay away from the brick
Metal brushes and scrapers can scratch brick and cut into joints. They can also leave small metal fragments in the surface that rust later and stain the face.
Masonry cleaning guidance warns against them for those reasons. We use stiff bristle brushes, wooden paddles and nonmetal tools instead. That takes a little more time, but the face is not marked by the cleaning. The same care applies around tile, stone and trim near the opening. Where a stubborn mortar smear needs removing, a wooden or plastic tool does the job without scarring the brick.
The restoration scope in writing
- Condition review of every fireplace part
- Surround tiles reset or matched
- Lintel condition noted
- Separate notes on chimney-side findings
Common fireplace restoration questions
What does a fireplace restoration include?
It returns a neglected fireplace to safe use and to the look it was built with, under one plan. Typical items are firebrick and firebox repairs, damper work, smoke chamber parging, face cleaning and repointing, and hearth repairs, each priced separately.
Do you replace every firebrick during a restoration?
No. Sound firebrick stays. We replace units that are loose, broken or badly eroded, and refill open joints with a heat-rated mortar. The estimate shows which units are to be replaced and where they sit.
Is restoration worth it if I will rarely light a fire?
If you will light it at all, the parts that keep a fire safe still need to work. If you will not burn in it, tell us, and we explain which items still matter for a fireplace that stays closed.
More Ways to Care for Your Fireplace
- Firebox RepairRepair the damaged fireplace chamber using an approach suited to masonry or manufactured components.
- Spalling Brick Repair and Chimney Brick ReplacementReplace deteriorated chimney bricks while retaining suitable surrounding masonry.
- Chimney Damper Repair and ReplacementRestore a usable damper mechanism after checking the plate, frame and control linkage.
- Chimney Masonry RepairRepair affected chimney brickwork and joints with materials selected for the construction already in place.
- Chimney TuckpointingRenew deteriorated mortar joints around chimney bricks that can appropriately remain.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo