Gas fireplace installation for homes in Chula Vista Isles
Book the approved installation within 72 hours of your free inspection and save 10%.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Projects that start with a gas fireplace plan
- Planning a fireplace for a room without one
- Wanting a fire without burning wood
- An old decorative unit that gives little heat
- A new deck crowding the old termination
Jump to
Our way of installing a gas fireplace in Chula Vista Isles
Adding a gas fireplace during a renovation
A renovation that opens walls or ceilings is a good moment to add a gas fireplace, because routes and framing can be built before finishes go on. It also means coordinating with trades already on site.
Tell us the renovation schedule and which walls will be open. We plan the appliance, vent and supply positions to fit it, and flag anything the manual requires that the renovation plan does not yet show. The fireplace work is priced as its own item, separate from the rest of the renovation.
Clearances to combustibles inside the framing
Inside the wall or chase, the appliance and its vent need specified air spaces to framing and other combustibles. The manual gives the figures for each model and warns that insulation and other materials must be secured so they cannot drift into those spaces.
We frame, or check the framing, against those clearances before insulation goes in. Spacers, standoffs and shields supplied with the appliance are fitted as shown. Once the wall is closed, those spaces cannot be seen, which is why they are checked and noted on your written record beforehand.
Termination clearances from openings
The fuel gas code and the appliance manuals set clearances between a vent termination and nearby features. These include openable windows and doors, soffits and overhangs, inside corners, meters and regulators, and air intakes. The figures differ between direct-vent and other terminals.
We measure the planned termination against the manual for your model and mark it before the wall is opened. Where two sources differ, the stricter one applies. If a clearance cannot be met, the termination or the fireplace moves, rather than the rule being bent.
Outside air kits on natural-draft models
Some natural-draft gas fireplaces accept an outside air kit. One manual recommends it, and it says the kit must be installed where negative pressure is present, to help the unit perform and to help prevent spillage of combustion gases.
If you choose a natural-draft model, we look at whether an outside air kit is listed for it and whether the house conditions call for one. The kit's route and inlet position are planned with the rest of the installation, and the control that closes it is shown during the walkthrough.
Line items for a new gas fireplace
- Framing and chase layout to the manual
- Clearances to combustibles marked out
- Noncombustible zones kept free of combustibles
- Shutoff valve position coordinated
Gas fireplace project questions we hear
Does a direct-vent unit need a chimney?
No. A direct-vent gas fireplace uses a sealed vent system that draws outside air and exhausts through a listed termination on a wall or roof. The route and termination must fit the manual's rules for that model.
Can you install a propane fireplace?
Yes, where the model is supplied for propane or converted as its manual allows. Your propane supplier or a gas contractor handles the tank, regulator and piping. We confirm the fuel on the rating plate before the unit is set in place.
Do you install gas log sets or vent-free fireplaces under this service?
No, those are separate services. Log sets have their own installation service, and vent-free fireplaces have their own requirements. This installation service covers vented gas fireplaces, either direct-vent or natural-draft.
More Ways to Care for Your Fireplace
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
- Wood-Burning Fireplace Insert InstallationFit a wood-burning insert after assessing its host fireplace and full connection requirements.
- Chimney Animal RemovalAssess occupied chimney openings and plan appropriate follow-up cleaning or entry protection.
- Chimney Liner Installation and ReliningPlan a compatible chimney liner installation with the existing passage, connections and maintenance access considered together.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo