Gas fireplace installation for homes in Doral
We install the appliance you approve, test it, and show you how it should run.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a gas fireplace installation makes sense
- Planning a fireplace for a room without one
- A particular look chosen for the wall
- No manual for the existing unit
- Controls you would like to update
Jump to
What a gas fireplace installation involves
Keeping insulation away from the unit and vent
Loose insulation, debris and stored items can end up against a fireplace or its vent if the enclosure is not blocked properly. One manual requires the chase to be blocked so that blown insulation and other combustibles cannot reach the fireplace or chimney.
We look at how insulation will be installed around the enclosure and where blocking is needed. Attic spaces get particular attention, because insulation is often added later by someone who does not know the vent is there. Where the manual supplies a shield for that job, it is fitted and recorded.
Sealing the wall penetration
When a vent passes through an outside wall, the fuel gas code requires the annular space around it to be permanently sealed with approved materials. That seal keeps combustion products from finding a way back into the building around the pipe.
We seal the wall penetration as the code and the vent manual require, using the materials they specify. The exterior termination is fastened and flashed or sealed to the wall covering as shown. Water and air tightness at the wall matter for the house as well as for the appliance.
An electrician for a new circuit
If the chosen model needs household power and there is no suitable outlet or circuit at the appliance position, an electrician installs it. Electrical work is governed by the electrical code, and it is outside our scope.
We tell the electrician what the manual requires, such as the type of supply and where the connection sits inside the unit. Their work fits into the rough-in, before the walls close. We connect the appliance side as the manual shows and test the controls once the supply is live.
Instructions on the job site at inspection
The Florida fuel gas code expects the manufacturer's installation instructions to be on the job site at the time of inspection. It also says that where the listing or the instructions are stricter than the code, they apply.
We keep the manual with the appliance throughout the work and follow it line by line. If a local requirement or an inspector asks for something beyond the manual, we discuss it with you and adjust the plan. The manual stays with the house when the job is finished.
Line items for a new gas fireplace
- Vent route checked against the vent tables
- Clearances to combustibles marked out
- Attic insulation shield where the route needs one
- Electrical requirement noted for an electrician
Gas fireplace project questions we hear
Does a direct-vent unit need a chimney?
No. A direct-vent gas fireplace uses a sealed vent system that draws outside air and exhausts through a listed termination on a wall or roof. The route and termination must fit the manual's rules for that model.
Can the fireplace go on an interior wall?
Sometimes. The vent route has to reach a permitted termination within the vent tables for the model. Longer routes and extra elbows can rule some positions out, so we check the route before you commit to that wall.
What does the free project inspection cover?
We look at the room, the intended position, possible vent routes, the framing and access, and the fuel supply situation. You then receive a written scope that separates our work from the work of other trades.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo