Built-in gas fireplace installation in Lauderdale Beach
Framing, firestops and vent clearances are built as the listing requires, then covered by your finish.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Gas fireplace projects we are asked about
- A unit bought before the route was checked
- Several trades working on one room
- An old decorative unit that gives little heat
- No manual for the existing unit
Jump to
Building a gas fireplace around its manual
Choosing the wall for the fireplace
The wall you choose decides the vent route, the framing and the finish. Outside walls often allow short horizontal runs to a termination. Interior walls may need a vertical run through the ceiling and roof, or a longer path that the vent tables may not allow.
During the project inspection we look at each candidate wall in turn. We check what is inside it, where the vent could go and what the termination would sit near. You then choose with a clear picture of what each position involves, rather than finding out after the wall is opened.
Drawings, builders and other trades
Gas fireplace projects often involve a builder, an electrician, a gas contractor and a finish trade. Each needs the manual's requirements that affect their work, such as framing sizes, clearances, noncombustible zones and supply positions.
Bring any drawings you have to the project inspection. We mark up the requirements for the chosen model and share them with the other trades before they start. When everyone works from the same manual, the finished opening fits the appliance and the appliance fits its listing.
The order of work on a gas fireplace project
A typical project moves from planning and ordering to framing and the rough-in of vent, supply and power. A check of the rough-in comes before the walls close, then finish work, then setting, connecting and commissioning the appliance. Some models are set earlier and protected during finishing.
We agree the order with you and any other trades at the start and write it into the scope. When a step depends on another trade, we say which one and why. That keeps the fireplace from waiting on a finish that has to be removed later.
Dust, debris and cleanup during the work
Installation involves cutting framing, opening walls or ceilings and handling packaging. We protect floors and furniture near the work area and control dust where cutting takes place.
Offcuts, packaging and old materials are removed as the job progresses. At the end, we clean up the debris and haul it away, leaving the room ready for the finish trade or for use. If other trades are working in the same room, we agree who clears what, so nothing is left behind.
Appliance, vent and framing items for your gas unit
- Wall and ceiling firestops where required
- Supply handover point agreed with the gas contractor
- Shutoff valve position coordinated
- Debris cleaned up and hauled away
Planning questions for a gas fireplace in Lauderdale Beach
Do you install gas log sets or vent-free fireplaces under this service?
No, those are separate services. Log sets have their own installation service, and vent-free fireplaces have their own requirements. This installation service covers vented gas fireplaces, either direct-vent or natural-draft.
Is the installation covered by a warranty?
Our workmanship warranty covers the installation work we carry out. The appliance and vent parts carry their manufacturers' own warranties. We explain both on the estimate so you know which covers what.
What if I smell gas after the new fireplace is installed?
Get everyone out of the house, leaving switches and the fireplace controls untouched. From the yard or the street, ring 911 or the gas utility, and stay out until they confirm the building is safe.
More Ways to Care for Your Fireplace
- Chimney Sweep and Chimney CleaningArrange careful chimney cleaning in Miami with a defined scope, protected work area and useful findings.
- Hurricane and Storm Damage Chimney RepairAssess storm-related chimney concerns and distinguish temporary protection from permanent component repair.
- Chimney WaterproofingTreat suitable chimney masonry after checking the surface, repair needs and product requirements.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo