Planning and installing a gas fireplace in Liberty City
Tell us where you want the fire, and we check whether a vent route and enclosure can support it.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Where gas fireplace installations usually begin
- An old gas unit you want replaced
- Unsure where a vent could exit
- A builder asking for framing details
- An old decorative unit that gives little heat
Jump to
Gas fireplace installation, from room to handover
Attic shields on vertical vent runs
When a vertical vent passes through an attic, insulation can fall or be blown against the pipe. Vent makers supply attic insulation shields to keep insulation clear of the vent and hold the required air space up to the roof deck.
If your route goes through the attic, we fit the shield listed for the vent system and check its height against the insulation depth. We also look at how easy the attic is to reach and whether future insulation work could disturb the vent. Those notes go on your written record.
Termination clearances from openings
The fuel gas code and the appliance manuals set clearances between a vent termination and nearby features. These include openable windows and doors, soffits and overhangs, inside corners, meters and regulators, and air intakes. The figures differ between direct-vent and other terminals.
We measure the planned termination against the manual for your model and mark it before the wall is opened. Where two sources differ, the stricter one applies. If a clearance cannot be met, the termination or the fireplace moves, rather than the rule being bent.
A gas odor during or after the project
If you notice a gas odor at any point, the first step has nothing to do with the project. Get everyone out of the house, leaving switches, phones and the fireplace controls untouched. When you are all outside, call 911 or the gas utility and follow their instructions about going back in.
The appliance should stay off until the source has been found. Once the house is declared safe, we can check the appliance connection and explain what we find. Any work that follows is agreed in writing before it starts, like every other part of the installation.
Ceiling height and the space above the unit
Manuals set minimum distances from the appliance to the ceiling and to anything combustible above it. Low ceilings, soffits and beams near the fireplace position can limit which models fit or where the unit can sit on the wall.
We measure the space above the planned position during the project inspection. If a raised installation is part of the design, we check that the ceiling clearances still work at that height. Those checks happen before framing, when changing the height is still simple.
What the gas installation quote includes
- Model selection against the room and route
- Termination position against listed clearances
- Control and service access planned
- Flashing and storm collar on roof terminations
Gas fireplace installs, questions answered
Does a direct-vent unit need a chimney?
No. A direct-vent gas fireplace uses a sealed vent system that draws outside air and exhausts through a listed termination on a wall or roof. The route and termination must fit the manual's rules for that model.
Can you install a propane fireplace?
Yes, where the model is supplied for propane or converted as its manual allows. Your propane supplier or a gas contractor handles the tank, regulator and piping. We confirm the fuel on the rating plate before the unit is set in place.
What does the free project inspection cover?
We look at the room, the intended position, possible vent routes, the framing and access, and the fuel supply situation. You then receive a written scope that separates our work from the work of other trades.
More Ways to Care for Your Fireplace
- Chimney RebuildRebuild the affected chimney section with the retained structure, roof connection and passage included in the plan.
- Chimney Liner Installation and ReliningPlan a compatible chimney liner installation with the existing passage, connections and maintenance access considered together.
- Ventless Gas Fireplace ServiceService the identified vent-free appliance without bypassing its required safety components.
- Chimney Leak RepairFind the chimney water entry point and plan a repair before restoring the damaged finish.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo