Installing natural gas and propane fireplaces in Pembroke Park
The termination position is checked against the manual before any wall opening is cut.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs it may be time for a new gas unit
- Planning a fireplace for a room without one
- Propane supply but no appliance yet
- A builder asking for framing details
- Cabinetry planned around the fireplace
Jump to
The parts of a gas fireplace project
Where a direct-vent unit gets its air
A direct-vent gas fireplace is sealed from the room. It draws combustion air from outside and sends combustion products back out through the same vent assembly, usually one pipe inside another. The glass front stays closed during operation.
That design gives more freedom over position, because the vent can end on a wall or a roof rather than needing a chimney. The freedom has limits, though. The manual sets the allowed vent lengths, elbows and termination clearances, and we plan the route within those limits before cutting anything.
An electrician for a new circuit
If the chosen model needs household power and there is no suitable outlet or circuit at the appliance position, an electrician installs it. Electrical work is governed by the electrical code, and it is outside our scope.
We tell the electrician what the manual requires, such as the type of supply and where the connection sits inside the unit. Their work fits into the rough-in, before the walls close. We connect the appliance side as the manual shows and test the controls once the supply is live.
Hot glass and household safety at the design stage
The glass and front of a gas fireplace get hot. Where young children or others at risk live in the home, manuals advise some form of physical barrier, and many models ship with a barrier screen. Placing the unit away from walkways and furniture also helps.
If children or pets will use the room, tell us during planning. We look at the position, the height and the space in front of the unit with that in mind. Safety gates are outside our work, but we explain what the manual recommends before the design is fixed.
A gas fireplace on an upper floor
An upper-floor fireplace may exit through a wall high above the ground or through the roof. Wall terminations above decks, balconies or porches have their own clearance rules in the manuals, and the termination must be reachable for future checks.
We look at what sits below and beside the planned exit point outside, including any deck or balcony. If a wall termination would be hard to reach or crowded, a vertical route may be better. The choice is made with both the appliance and future service in mind.
What the gas installation quote includes
- Clearances to combustibles marked out
- Attic insulation shield where the route needs one
- Noncombustible zones kept free of combustibles
- Restrictor set for the vent configuration
Before you plan a gas fireplace
Can the fireplace go on an interior wall?
Sometimes. The vent route has to reach a permitted termination within the vent tables for the model. Longer routes and extra elbows can rule some positions out, so we check the route before you commit to that wall.
Is there a discount on a gas fireplace installation?
Yes. Once the free inspection is done, you have 72 hours to approve the installation, or any service we quote, at 10% off. The window counts from your own inspection and is shown on the estimate.
Can you install a propane fireplace?
Yes, where the model is supplied for propane or converted as its manual allows. Your propane supplier or a gas contractor handles the tank, regulator and piping. We confirm the fuel on the rating plate before the unit is set in place.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo