Direct-vent and B-vent gas fireplace installation in Richmond West
From selection to handover, a gas fireplace installation in Richmond West with no hidden fees.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Projects that start with a gas fireplace plan
- A unit bought before the route was checked
- Cabinetry planned around the fireplace
- A particular look chosen for the wall
- No manual for the existing unit
Jump to
Installing vented gas fireplaces in Richmond West
Items other trades carry
A gas fireplace installation touches several trades. Supply piping and the shutoff valve belong to a gas contractor or the utility. New circuits belong to an electrician. Tile, stone, drywall and paint belong to the finish trade. Roof covering work beyond the flashing belongs to a roofer.
We coordinate the sequence and give each trade the manual's requirements for their part. Their work is priced and carried out by them. The estimate makes those boundaries clear, so no one assumes a task is covered when it is not.
The installation discount after your inspection
Approve the installation no more than 72 hours after your free inspection, and the agreed price carries a 10% discount. The same applies to any other service we quote after that inspection, and the window counts from your own visit.
There is no pressure to decide on the spot. The estimate shows the reduced price, so you can compare it, ask questions and talk it over at home. Approving later is fine, and the plan stays the same. Only the price changes, and the estimate states both figures.
Power vent kits for difficult routes
Some manufacturers offer power vent kits for certain models, allowing routes that would not work with natural draft or a standard direct-vent run. A power vent adds a fan, its own electrical supply and its own installation rules.
One manual asks for a safety inspection of the venting system before and after a power vent is installed. It also requires the power vent to be reachable through an access panel. We explain whether a power vent is listed for your model and what it adds to the project before you decide.
No substitute parts during the installation
One manufacturer disclaims responsibility, and voids its warranty, where the appliance or vent system is modified, installed other than as instructed, or fitted with parts it has not approved. Log and glass positions set incorrectly are on the same list.
We install only the parts supplied or listed for your model and vent system, placed as the manual shows. If a site condition seems to call for a different part, we stop and find a listed answer. That keeps the manufacturer's warranty in place and the appliance within the listing it was tested under.
What a gas fireplace project in Richmond West includes
- Fuel type matched to the house supply
- Vent route checked against the vent tables
- Control and service access planned
- Vent assembled with every joint locked
Questions about installing a gas fireplace
What happens on the day the new fireplace is lit?
We check the appliance connection for leaks, take pressure readings, light the unit and watch it through its sequence. Then we show you the controls, the barrier and the maintenance list in the manual.
Can you move an existing gas fireplace to another wall?
Moving a unit is treated as a new installation at the new position, with its own vent route, framing and supply coordination. The old opening and vent need closing properly, which may involve other trades.
Should the fireplace go in before or after the finish work?
The appliance, framing and vent come first, and the finish follows to the manual's requirements. Some models allow certain finish materials only in set zones. We agree the sequence with your builder so nothing has to be undone.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo