New vented gas fireplaces installed in Sandalfoot Cove
Tell us where you want the fire, and we check whether a vent route and enclosure can support it.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Situations that lead to a new gas unit
- A renovation opening up the wall
- Unsure where a vent could exit
- A particular look chosen for the wall
- A new deck crowding the old termination
Jump to
Our gas fireplace installation service in Sandalfoot Cove
Gas fireplaces in new construction and additions
In new construction or an addition, the fireplace can be planned while the framing is open, which makes routing and blocking simpler. The appliance still dictates the framing, clearances and termination, so the model should be chosen before the frame goes up around it.
We work with your builder on the sequence. The rough framing, vent route and supply positions are set to the manual, then checked before insulation and wall covering. Late changes to the model can mean reframing, so we confirm the choice in writing before that stage.
Horizontal terminations and moisture
A horizontal termination sits on an outside wall. One manual asks for the termination cap to slant slightly downward so moisture in the cap can drain out. The same manual allows horizontal runs to be level rather than rising.
We set the termination and the last section of the run to the manual's instructions. The cap is fastened to the wall as shown, sealed where the manual calls for it and checked for the clearances it needs outside. A cap mounted the wrong way can hold water against the wall and the vent.
The order of work on a gas fireplace project
A typical project moves from planning and ordering to framing and the rough-in of vent, supply and power. A check of the rough-in comes before the walls close, then finish work, then setting, connecting and commissioning the appliance. Some models are set earlier and protected during finishing.
We agree the order with you and any other trades at the start and write it into the scope. When a step depends on another trade, we say which one and why. That keeps the fireplace from waiting on a finish that has to be removed later.
Pressure readings and the operating check
Before handover, the appliance is commissioned as its manual describes. That usually includes inlet and manifold pressure readings, a check of the pilot and burner flames, and a look at ignition across the whole burner.
We record the readings and compare them with the manual's figures for your fuel. The unit is run through its controls, including remote, thermostat and blower where fitted. If a reading or behavior falls outside the manual, we find the cause before handover rather than leaving it for the first service visit.
Line items for a new gas fireplace
- Clearances to combustibles marked out
- Floor surface under the appliance
- Control and service access planned
- Appliance set, leveled and secured
Before you plan a gas fireplace
Can a gas fireplace share a vent with another appliance?
The manuals we work from call for a separate vent and prohibit venting into a pipe that serves a solid-fuel appliance. We plan a dedicated vent for the new unit as its manual specifies.
What if the wall I want has no room for the vent route?
We look for another route or another position that fits the vent tables and termination rules. If no permitted route exists for that wall, we say so plainly and suggest positions that do work.
Can you move an existing gas fireplace to another wall?
Moving a unit is treated as a new installation at the new position, with its own vent route, framing and supply coordination. The old opening and vent need closing properly, which may involve other trades.
More Ways to Care for Your Fireplace
- Chimney Sweep and Chimney CleaningArrange careful chimney cleaning in Miami with a defined scope, protected work area and useful findings.
- Gas Fireplace Repair and ServiceGet a model-specific gas fireplace service plan for the fault you are seeing or the maintenance your unit needs.
- Stone Chimney RepairRepair affected stone chimney surfaces with the supporting construction and visual match considered together.
- Fireplace RestorationCoordinate fireplace repairs while preserving suitable existing features and defining the intended use.
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo