Flagami gas fireplace repair, starting with diagnosis
Your free inspection separates a repair from routine care, so you approve only the work the unit needs.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a gas fireplace stops behaving normally
- Main burner will not come on
- Remote no longer controls the fire
- Wall switch does nothing at all
- Rust or peeling paint in the firebox
Jump to
Servicing vented gas appliances, model by model
Flames that lift away from the burner
Flames that lift off the burner, flicker hard or change color can point to pressure, air shutter or orifice problems. On some installations they can also come from the vent. The flame is only the symptom, and the cause needs measurement rather than a quick turn of an adjustment screw.
We take inlet and manifold pressure readings where the model provides test points, and check that the orifice matches the size the parts list gives for your fuel. Settings change only within the manual's instructions. If a vent fault is suspected, we explain that it belongs to a separate venting scope.
The gas supply up to the appliance
The piping that brings gas to your fireplace, the meter and the supply side of the shutoff valve are the gas utility's or a gas contractor's responsibility. We do not install or alter supply piping. Our work begins at the appliance and its listed connection.
If a pressure reading or leak check at the appliance points to the supply, we explain the finding. The utility or a gas contractor should then look at it. The appliance stays off until that question is settled. We can return to finish the appliance work once the supply is confirmed.
Lint, dust and pet hair inside the unit
One manufacturer notes that lint from carpeting and bedding can call for more frequent cleaning than usual, and another lists pet hair among the things to clear from the compartment. Lint and hair collect around burners and in circulating air passages too, where they can affect ignition and airflow.
If your home has pets or a lot of textiles near the fireplace, mention it when booking. We clean the areas the manual lists and look at the blower and air passages with extra care. You get a note of what we removed, which helps judge how often your unit needs attention.
Findings explained in plain language
Gas fireplace faults involve parts with unfamiliar names, and it is fair to expect an explanation you can follow. We name the part, say what it does, describe what we found and explain why it matters for the way the unit lights or runs.
If you want to see the part, we show it to you where that is safe. The same explanation goes into the written record, so you can read it again later or share it with someone else in the house. Questions are welcome at any point, before and after you approve the work.
What we check on a gas unit
- Leak check at fittings we disturb
- Log and ember placement against the diagram
- Air shutter setting check
- Draft check on draft-hood models
Questions about servicing a gas fireplace
What does the free inspection include for a gas fireplace?
We identify the unit, look at the accessible parts, operate it where that is safe, and explain what we found. You receive a written scope for any repair or service before you decide anything.
What if the unit keeps shutting down soon after it lights?
That pattern can involve the pilot, flame sensing, the control module, the venting or supply pressure. We check them in a sensible order and tell you what the findings show before recommending any part.
Do you service the remote and receiver as well?
Yes, as part of the control system. Pairing, batteries, receivers and wall switches are checked against the model's instructions. A failed receiver is replaced with the part the manual lists for that valve.
More Ways to Care for Your Fireplace
- Gas Fireplace VentingAssess and repair the gas fireplace vent arrangement using components suited to the identified system.
- Chimney Sweep and Chimney CleaningArrange careful chimney cleaning in Miami with a defined scope, protected work area and useful findings.
- Chimney WaterproofingTreat suitable chimney masonry after checking the surface, repair needs and product requirements.
- Chimney Flue RepairAssess repairs to damaged existing flue linings and distinguish them from a new liner installation.
- Chimney Cap Installation and ReplacementProtect the chimney opening with a cap chosen for its fit, attachment and compatible system.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo