Gas fireplace vent repair and replacement in Bayside
We explain what we could see, what stayed concealed and what the vent work would involve.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Gas vent problems you may notice in Bayside
- Termination cap bent or crushed
- Fireplace shuts down soon after lighting
- Soot marks near the draft hood
- Pipe resting against attic insulation
Jump to
Our gas fireplace venting service in Bayside
Soot marks near the fireplace or termination
Dark marks around a draft hood opening, on the wall near a termination or inside the room can point to spillage or incomplete combustion. The manuals link negative pressure with spillage of fumes and soot, and soot at the logs with flame contact.
We look at where the marks are and what they suggest. Marks at the draft hood or around the vent point to the vent and the house pressure. Marks on the logs and glass point to the appliance. Each finding is routed to the right service and explained before you approve anything.
B-vent installation from appliance to roof
A new Type B vent runs from the appliance draft hood or collar up to a listed cap above the roof. Along the way it needs firestop spacers at ceilings, an attic insulation shield where it crosses insulation, supports, roof flashing and a sealed storm collar.
We size and lay out the route to the appliance manual and the fuel gas code, using parts from one listed Type B system. The height above the roof follows the code's rules for the roof and nearby walls. Each stage is checked before ceilings and roof are closed up.
Outside air kits on natural-draft units
An outside air kit, where the model accepts one, brings combustion air in from outdoors rather than from the room. The maker of one such model recommends the kit and makes it mandatory under negative pressure, to support performance and to help stop combustion gases spilling.
If a draft check shows spillage and the house runs at negative pressure, we look at whether an outside air kit is listed for your model. Its inlet position and route are planned like any other vent part. The kit's control, which can be closed when the fireplace is not in use, is shown to you afterwards.
Vent-free units have no vent to repair
A vent-free gas fireplace or log set does not use a vent. Its combustion products stay in the room, and its listing depends on protective devices and limits on room size.
If your appliance is vent-free, this venting service does not apply. It is handled under our ventless gas fireplace service, which follows the requirements for that design. If you are not sure whether your appliance is vented, the rating plate and manual will say, and we can check it for you.
Gas vent parts and checks for Bayside homes
- Appliance and vent system identification
- Accessible joints checked for full engagement
- Concealed sections recorded as not seen
- Gas vent inside a masonry chimney reviewed
Direct-vent and B-vent questions we hear
What records do I get after vent work?
A written record of the work that lists the appliance, the vent maker and system, and the route. It also covers the parts replaced, the checks made and anything that stayed concealed or outside the scope.
What should I do if a carbon monoxide alarm goes off?
Get everyone outside into fresh air, then call 911 from there. Stay out until the responders allow you back in, and leave the fireplace off until the vent and appliance have been inspected.
Can you check the vent without taking the fireplace apart?
Partly. Exposed pipe, the termination and the roof or wall exit can often be checked without opening the appliance. The collar connection and concealed joints may need panels or access opened, which we explain before doing it.
More Ways to Care for Your Fireplace
- Chimney TuckpointingRenew deteriorated mortar joints around chimney bricks that can appropriately remain.
- Wood-Burning Fireplace Insert InstallationFit a wood-burning insert after assessing its host fireplace and full connection requirements.
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
- Chimney Sweep and Chimney CleaningArrange careful chimney cleaning in Miami with a defined scope, protected work area and useful findings.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo