Direct vent fireplace repair for Lauderdale-by-the-Sea homes
Upfront pricing for vent work in Lauderdale-by-the-Sea, with any access or finish repair listed separately.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs a gas fireplace vent needs attention
- Termination cap bent or crushed
- Visible gap at a pipe joint
- Soot marks near the draft hood
- Rattling cap on a windy day
Jump to
Tracing gas vent faults from collar to cap
Leaks at a roof penetration
A vertical gas vent passes through the roof with flashing and a storm collar. One vent maker calls for a ring of nonhardening high-temperature sealant, such as silicone, around the pipe at the top of the storm collar to keep the roof watertight.
A ceiling stain near a vertical vent can mean the collar, sealant or flashing has failed. We check them where the roof can be reached safely and explain what we find. Vent-side repairs are quoted by us. If the roof covering around the flashing needs work, a roofer handles it.
Termination caps after strong wind
Strong wind and flying debris can loosen, bend or knock off a termination cap. A cap that is missing or twisted lets rain, debris and animals into the vent and can change how the appliance breathes.
If you notice damage at the termination after strong wind, leave the fireplace off and tell us. We check the cap, the pipe behind it and the wall or roof seal, and quote the listed replacement parts. Wider damage to the roof or wall covering is listed for the right trade.
Opening a wall or ceiling to reach the vent
Direct-vent pipe is tested to run inside enclosed walls, and one manual notes there is no requirement for inspection openings at each joint. That means concealed faults can only be confirmed by opening the wall or ceiling.
We do not open finished surfaces without your approval. The estimate shows where access is needed, how large the opening should be and why. Restoring the finish afterwards is listed as its own item, either by us or by a finish trade, so the cost of access is clear before you decide.
The operating check after vent work
After the approved vent work, the fireplace is run through its normal sequence. We watch the ignition, the flame and the controls, and on natural-draft units we repeat the draft check at the draft hood once the unit has warmed up.
We also look at the termination while the appliance runs, where that can be done safely. If the appliance behaves differently from what the vent findings predicted, we tell you before we leave. A vent repair that leaves an appliance fault untouched is not described as a finished fix.
The gas venting scope you approve
- Appliance and vent system identification
- Roof flashing and storm collar condition
- Clearance to later decks, fences and additions
- Decorative shroud listing confirmed
Gas venting questions for Lauderdale-by-the-Sea homes
Can you replace just the termination cap?
Yes, if the rest of the system is sound and the cap listed for your vent system is available. We confirm the vent maker and system from the labels before ordering, and check the joints nearest the cap while we are there.
Can the gas vent share a flue with a wood-burning fireplace?
No. The manuals we work from require a separate vent and prohibit venting into a pipe serving a solid-fuel appliance. The fuel gas code also calls for gas vents inside masonry chimneys to be labeled for gas appliances only.
Can you check the vent without taking the fireplace apart?
Partly. Exposed pipe, the termination and the roof or wall exit can often be checked without opening the appliance. The collar connection and concealed joints may need panels or access opened, which we explain before doing it.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo