Direct vent fireplace repair for Little Gables homes
B-vent installation and replacement with listed parts, supports and a properly sealed roof exit.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What a failing gas vent can look like
- Flashing lifted around a roof vent
- Fireplace shuts down soon after lighting
- Pipe resting against attic insulation
- Rattling cap on a windy day
Jump to
Gas vent pipes, joints and terminations
Corrosion or separation along exposed pipe
One owner's manual lists corrosion and separation among the routine checks for the venting system. Exposed pipe outdoors and in attics can rust, lose its finish or pull apart at joints over time.
We look along every accessible section for rust, holes, loose joints and damaged finishes. Surface wear is noted for watching. A section that has corroded through or separated is replaced with the listed part from the same system. Where the damage points to a wider problem, such as water entering at the roof, we explain that too.
Painting exterior galvanized vent parts
One vent maker explains that outdoor galvanized parts last longer and look better when painted properly. Oil and dirt are removed first, then a primer recommended for adhesion to galvanized steel goes on before the finish coat.
If exposed vent parts are rusting or peeling, we explain whether painting is enough or whether the part has corroded too far. Paint work is not a substitute for a failed part. Where replacement is needed, the listed part is quoted, and finishing it is noted on the estimate.
Clearances around a direct-vent wall termination
Through-the-wall terminations have their own clearance table in the fuel gas code, which separates direct-vent terminals from others. Appliance manuals add their own figures for features such as soffits, inside corners, meters and walkways.
We measure an existing wall termination against both and use the stricter figure where they differ. The results are written on your record. If a clearance is not met, we explain which feature is too close and whether the termination, or the feature, is the more practical thing to move.
When the vent system is no longer made
Vent systems are sometimes discontinued, and replacement sections may become hard to find. Because the manuals prohibit mixing systems, a missing part cannot simply be swapped for a similar one from another maker.
If the original system is no longer available, we check the appliance manual for other approved vent systems. Where one is listed, the affected run may need replacing from the appliance to the termination with the new system. We explain the extent of that work before quoting it.
What your gas vent estimate covers
- Route traced from collar to termination
- Accessible joints checked for full engagement
- Blockage from nests, plants or debris
- Operating check after the vent work
Questions about gas fireplace venting
Can a new air conditioning unit affect the vent termination?
It can. Terminations need distance from mechanical air intakes so combustion products are not drawn into the house, and equipment placed close to a cap can crowd it. We measure the arrangement against the manual and explain which item would need to move.
Will you check the roof flashing around a vertical vent?
Yes, as part of the vent route. We look at the flashing, storm collar and sealant around the pipe where the roof can be reached safely. Roofing work beyond the flashing is referred to a roofer and priced by them.
What if the pipe inside the wall has come apart?
A separated joint is corrected with the listed parts and locking method once it can be reached. The appliance stays off until then. Access and restoration are priced separately from the vent repair itself.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo