Gas fireplace vent repair and replacement in Ojus
We explain what we could see, what stayed concealed and what the vent work would involve.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What a failing gas vent can look like
- Termination cap bent or crushed
- Plants grown over the termination
- A porch enclosed around the termination
- Rattling cap on a windy day
Jump to
Vent work for gas fireplaces in Ojus
A hot termination cap beside a path
Termination caps get hot while the fireplace runs. One manual warns of burns and asks installers to think about caps near doors, walkways, decks and gathering spots. It offers listed cap shields for some systems.
If a termination sits where people brush past it, we explain the options. A listed cap shield for your system may help. In other cases relocating the termination within the vent tables is the better answer. Either change is quoted, and only listed parts are used.
Gas and wood caps on the same roof
A staggered pair of terminations, one gas and one wood-burning, must have the wood-burning top standing above the gas cap under one manual's rules. The arrangement keeps smoke from the wood appliance away from the gas termination.
We check the relationship between the two terminations and explain what the manual requires. If the gas cap sits higher or too close, relocating or extending the gas vent within its tables may be the answer. Work on the wood-burning chimney itself belongs to our chimney services and is quoted separately.
Approving vent work before it starts
After the assessment, you receive an estimate naming the fault, the proposed vent repair, the parts and any access or restoration involved. Nothing is started, opened or ordered until you approve it. Questions about any line are welcome before you decide.
If we find something new once work begins, such as a second separated joint behind the one we were fixing, we stop and explain it. The additional work gets its own price and your approval. The final invoice then matches the scope you agreed.
A new fireplace is an installation project
If the vent problem is one of several reasons the fireplace is no longer worth repairing, a replacement appliance may make more sense. A new gas fireplace is planned under our gas fireplace installation service, with its own vent route, framing and supply coordination.
We explain when an existing vent could serve a new appliance and when it could not. Only a vent system the new manual lists may stay. The decision is yours, and we set out the facts rather than pushing a replacement where a vent repair would do.
Line items for gas vent work
- Termination cap condition and fastening
- Firestops and wall shields at crossings
- Roof flashing and storm collar condition
- Separate vent confirmed for the appliance
Gas venting questions for Ojus homes
Why does direct-vent pipe have an inner and outer pipe?
A direct-vent system usually runs one pipe inside another. Outside air for the fire comes in through one passage and exhaust leaves through the other, and both stay sealed from the room, which is why each joint and gasket matters.
Can you tell whether my vent was installed correctly?
We compare what can be seen with the appliance and vent manuals, including the route, parts, supports, clearances and termination. We explain what matches, what does not and what we could not see.
What should I do if a carbon monoxide alarm goes off?
Get everyone outside into fresh air, then call 911 from there. Stay out until the responders allow you back in, and leave the fireplace off until the vent and appliance have been inspected.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo