Direct vent fireplace repair for Pinewood homes
A vent fault is traced along the whole route, from the appliance collar to the termination.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Gas vent problems you may notice in Pinewood
- Visible gap at a pipe joint
- Ceiling stain near a vertical vent
- Flashing lifted around a roof vent
- A porch enclosed around the termination
Jump to
Tracing gas vent faults from collar to cap
Water or air around the wall penetration
Around a vent that crosses an outside wall, the gap between pipe and wall must be permanently sealed with approved materials under the fuel gas code. That seal keeps combustion products from entering the building around the vent and also helps keep weather out.
Cracked or missing sealant, gaps behind the termination plate and stains on the inside wall are signs worth mentioning. We check the seal from outside and, where it can be reached, from inside. The penetration is resealed with the materials the vent instructions name, and damaged finishes are listed separately.
Corrosion or separation along exposed pipe
One owner's manual lists corrosion and separation among the routine checks for the venting system. Exposed pipe outdoors and in attics can rust, lose its finish or pull apart at joints over time.
We look along every accessible section for rust, holes, loose joints and damaged finishes. Surface wear is noted for watching. A section that has corroded through or separated is replaced with the listed part from the same system. Where the damage points to a wider problem, such as water entering at the roof, we explain that too.
Working on a vent from the roof
Roof terminations are checked and repaired from the roof where access is safe. Steep, fragile or wet roofs may limit what can be done on a given day. We tell you in advance if the roof itself limits access.
On the roof we look at the cap, storm collar, sealant, flashing and the height of the termination. Repairs to vent parts are carried out with care for the roof covering. Where the covering itself is damaged, we describe it and suggest a roofer, rather than disturbing a roof we are not responsible for.
A new fireplace is an installation project
If the vent problem is one of several reasons the fireplace is no longer worth repairing, a replacement appliance may make more sense. A new gas fireplace is planned under our gas fireplace installation service, with its own vent route, framing and supply coordination.
We explain when an existing vent could serve a new appliance and when it could not. Only a vent system the new manual lists may stay. The decision is yours, and we set out the facts rather than pushing a replacement where a vent repair would do.
Items in a gas fireplace vent repair
- Appliance and vent system identification
- Vent maker and system read from labels
- Vent tables checked for any new route
- Operating check after the vent work
Common questions on gas vent repair
What does a B-vent installation from you include?
Listed Type B pipe and fittings, with the firestop spacers, attic insulation shield, supports, roof flashing, storm collar and listed cap the vent maker specifies. The route is sized and set to the appliance manual and the fuel gas code.
What is a draft check on a natural-draft fireplace?
After warm-up, a test at the draft hood relief opening shows which way the exhaust is moving, up the vent or back out into the room. We carry it out during vent work on draft-hood appliances.
Is a discount available on vent repairs?
Yes. Approve the vent work, or anything else we quote, during the 72 hours after your free inspection, and it comes with 10% off. The window starts from your own inspection and is written on the estimate.
More Ways to Care for Your Fireplace
- Wood-Burning Fireplace Insert InstallationFit a wood-burning insert after assessing its host fireplace and full connection requirements.
- Fireplace RestorationCoordinate fireplace repairs while preserving suitable existing features and defining the intended use.
- Smoke Chamber RepairRepair identified smoke-chamber surfaces with the access and material requirements clearly defined.
- Chimney Sweep and Chimney CleaningArrange careful chimney cleaning in Miami with a defined scope, protected work area and useful findings.
- Chimney Damper Repair and ReplacementRestore a usable damper mechanism after checking the plate, frame and control linkage.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo