Gas fireplace vent repair and replacement in San Marco Island
Direct-vent and natural-draft vents follow different rules, and we treat each one by its own manual.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Outside and inside signs of gas vent trouble
- Vent pipe loose where it meets the wall
- Ceiling stain near a vertical vent
- Pipe resting against attic insulation
- Rattling cap on a windy day
Jump to
Gas vent pipes, joints and terminations
A blocked gas vent termination
A termination that cannot breathe freely can affect how the fireplace lights and burns. One owner's manual lists plants, bird nests, leaves and debris among the things to look for at the termination during routine checks.
We inspect the termination from outside, clear loose debris where that can be done without disturbing the cap and check the screen or guard for damage. If the blockage has damaged the cap, or has worked its way into the pipe, we explain what repair is needed and quote it before any parts are ordered.
Termination caps after strong wind
Strong wind and flying debris can loosen, bend or knock off a termination cap. A cap that is missing or twisted lets rain, debris and animals into the vent and can change how the appliance breathes.
If you notice damage at the termination after strong wind, leave the fireplace off and tell us. We check the cap, the pipe behind it and the wall or roof seal, and quote the listed replacement parts. Wider damage to the roof or wall covering is listed for the right trade.
The written record of the vent work
Every vent visit closes with a written record of the work. On it are the appliance, the vent maker and system, the route as far as it could be seen, the parts replaced, the checks made and any draft results.
It also notes what stayed concealed and any limits we placed on use. Keep the record with the appliance manual. The next person to work on the vent can see which sections were replaced, which were checked and which could not be reached.
Adapters between the appliance and the vent
Some appliances connect to their vent through a listed adapter or starter section, particularly when a different vent series is used. The fuel gas code allows fasteners through a double-wall vent only at certain transitions, such as from a flue collar to the vent.
We check that any adapter is the one the appliance manual lists for the vent series in use. Homemade transitions or adapters from another product are replaced with the listed part. The adapter's part number goes on the record, because it tells the next person which vent series the system uses.
Checks and parts on your venting quote
- Termination cap condition and fastening
- Separate vent confirmed for the appliance
- Access opening and restoration priced separately
- Operating check after the vent work
Before you book gas vent work
Is a decorative shroud allowed over the termination?
Only a listed decorative cap or shroud made for your vent system. The manuals warn that decorative covers can change the clearances a cap needs, so we check the listing and the clearances before fitting one.
Can a new window or door near the termination cause a problem?
It can. Terminations need clearances from openable windows and doors, and a new opening can fall inside them. We measure the relationship against the manual and explain whether the termination or the opening needs to change.
Can you work on a power vent fitted to a gas fireplace?
Where the power vent is listed for the appliance, we can assess it and follow its manual. That manual calls for the venting to be safety-checked before and after any installation work. Its household circuit stays with an electrician.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo