Venting for gas fireplaces in Wilton Manors, checked end to end
Replacement pipe, caps and firestops come from the listed system, not from whatever fits the diameter.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What a failing gas vent can look like
- Visible gap at a pipe joint
- Water marks around the wall penetration
- Pipe resting against attic insulation
- Rattling cap on a windy day
Jump to
From the appliance collar to the termination cap
What the code expects a vent to do
Under the fuel gas code, venting systems must carry all flue and vent gases to the outdoors. It also requires the vent to meet the draft requirements the appliance manufacturer sets. A vent that leaks, spills or is blocked fails at both.
We judge vent work against those two points. A repair that looks tidy but leaves a joint that can separate, or a termination that can block, does not meet them. We explain in plain terms how each proposed repair restores the vent's job for your appliance.
Termination caps after strong wind
Strong wind and flying debris can loosen, bend or knock off a termination cap. A cap that is missing or twisted lets rain, debris and animals into the vent and can change how the appliance breathes.
If you notice damage at the termination after strong wind, leave the fireplace off and tell us. We check the cap, the pipe behind it and the wall or roof seal, and quote the listed replacement parts. Wider damage to the roof or wall covering is listed for the right trade.
B-vent installation from appliance to roof
A new Type B vent runs from the appliance draft hood or collar up to a listed cap above the roof. Along the way it needs firestop spacers at ceilings, an attic insulation shield where it crosses insulation, supports, roof flashing and a sealed storm collar.
We size and lay out the route to the appliance manual and the fuel gas code, using parts from one listed Type B system. The height above the roof follows the code's rules for the roof and nearby walls. Each stage is checked before ceilings and roof are closed up.
When a roofer joins the job
Roof terminations pass through the roof covering with flashing and a storm collar. Vent-side parts, such as the pipe, collar, sealant and cap, are within our work. The roof covering around the flashing may need a roofer, depending on the material and its condition.
We explain where our work ends and the roofer's begins before anything is started. If the roof around the vent has been leaking, the roofer may need to repair the covering after we renew the vent parts. The order is agreed in advance so the roof is not opened twice.
Gas vent work and separate access items
- Vent maker and system read from labels
- Route traced from collar to termination
- Restrictor setting against the route
- Limits on use explained in writing
Common questions on gas vent repair
Is a decorative shroud allowed over the termination?
Only a listed decorative cap or shroud made for your vent system. The manuals warn that decorative covers can change the clearances a cap needs, so we check the listing and the clearances before fitting one.
Is a manual damper allowed in a gas vent?
Not in the vent connector. The fuel gas code prohibits manually operated dampers there, because a closed damper could stop the vent working. Listed automatically operated vent dampers are a different matter and follow their own instructions.
Is a discount available on vent repairs?
Yes. Approve the vent work, or anything else we quote, during the 72 hours after your free inspection, and it comes with 10% off. The window starts from your own inspection and is written on the estimate.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo