Hearth repair for fireplaces in North Bay Village
A cracked or loose hearth is checked at the surface and beneath it before any tile, stone or brick is replaced.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs the hearth needs more than grout
- Cracks running across several tiles
- The hearth sloping toward the room
- Grout crumbling near the opening
- Loose bricks along the hearth border
Jump to
Hearth repair that starts with the cause
Cracked stone slab hearths
A hearth made from one or a few large stone slabs can crack from a heavy blow, a point load or an uneven bed beneath. A crack through a slab often runs from edge to edge.
We check whether the slab still sits firmly and whether the two sides of the crack are level. A stable crack in a well-supported slab may be left and watched. A slab that rocks or has dropped on one side needs lifting and rebedding or replacing, and we discuss matching stone before anything is removed.
Concrete hearths with cracks or broken edges
Cast concrete hearths can crack across their width or break at the front edge. Fine shrinkage cracks are common and often stable. Cracks that open, step or come with a loose edge are a different matter.
We check whether the concrete is sound around the crack and whether it is moving. Broken edges can often be rebuilt with a repair material suited to the location. A slab that has cracked through and dropped may need a section replaced, and the estimate explains which route fits.
Opening a small section to check the support
Sometimes the surest way to learn why a hearth keeps cracking is to lift part of it. Taking up a few tiles or a small area of brick shows the bed, the base and sometimes the support itself.
We choose the spot that will tell us the most with the least disturbance. The opening is protected while it is open and made good afterwards, or folded into the repair if you go ahead. The cost of that step is shown on its own line before we begin.
Checking hearth size in North Bay Village
Hearths in North Bay Village are checked against the fireplace they serve. If the extension looks short for the opening, we measure both and explain what the rules call for. Hearths that were trimmed during an earlier renovation come up often.
Extending the hearth is priced as its own item, with the new section's base, finish and floor edge described. If the hearth is large enough, we say so plainly and the repair stays with the surface or support. The finding is written down even if you decide to wait.
Hearth materials and steps in writing
- Support type identified where visible
- Temporary make-safe for loose edges
- Old hearth material hauled away
- Written record listing hearth materials
Questions about tile, stone and brick hearths
Is my hearth big enough for the fireplace?
That depends on the fireplace. A masonry fireplace follows the code's rules for the extension, which grow with the size of the opening. A factory-built unit follows its own manual. We measure both on the visit and tell you plainly whether the hearth falls short.
Can a rug sit on top of the hearth?
The hearth extension is meant to stay clear and noncombustible across its whole area. A rug over it sits exactly where embers land. Keep rugs off the hearth and back from its edge, and move them before our visit so we can see the whole surface.
Is it safe to sit on a raised hearth?
A sound raised hearth is built to carry its own weight and the loads placed on it, including people sitting on the edge. Loose capstones or corners are a different matter. Keep off loose sections until they are reset, and mention them when you book.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo