Hearth and hearth tile repairs in Sunny Isles Beach
A written record of the work notes what was replaced on the surface and what was done beneath it.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Clues that the hearth has moved
- A tile that sounds hollow underfoot
- Chipped or loose edge pieces
- Flooring tucked under the hearth edge
- A raised hearth that flexes when sat on
Jump to
The steps of a hearth repair
Flush hearths and raised hearths
A hearth extension can sit flush with the room floor or stand above it as a raised platform. Brick industry guidance describes both, noting that a raised hearth brings the fire closer to eye level and can double as seating.
Each type fails in its own way. Flush hearths tend to crack with the floor around them. Raised hearths tend to loosen at their edges and corners, where people step and sit. We look at the type you have and plan the repair around the stresses it actually takes.
Cantilevered hearths and cracks at the wall line
Some hearth extensions are carried as a cantilever of reinforced brick or concrete, projecting from the fireplace base. A crack across the hearth near the wall line can be a sign the cantilever is under strain. Cantilevers are hidden once the hearth is finished, so the surface is often the only clue.
We look for sag at the front edge, cracks on the underside where visible, and whether the crack is opening. Repairs to a cantilevered support go beyond the surface finish, and we explain what they involve. Surface work waits until the support question is settled.
Mortar that suits the hearth's brick or stone
Preservation guidance on repointing advises mortar that is no harder than the masonry it holds. Movement and stress then show up in the joint rather than in the brick or stone. Hard mortar in soft brick can cause the units to crack.
We choose hearth mortar to suit the units in place. Where an earlier repair used an overly hard mortar that is damaging the edges, we explain it and include its removal. The estimate names the mortar type in plain terms without quoting mixes.
Carrying ash across the hearth
Ash removal happens over the hearth, so spills and dropped embers land on it first. EPA advises putting ashes in a covered metal container and keeping that container outdoors, away from the house.
Set the container on the hearth itself while you fill it, not on the rug or the floor beyond. Use a metal shovel and move slowly near chipped edges or loose tiles. If ash has been working into open grout or cracks, tell us, because warm ash in a gap can reach whatever lies beneath. The repair closes those gaps.
Your hearth estimate, layer by layer
- Hearth type and finish identified
- Floor boundary named on the estimate
- Extension added where the hearth falls short
- Floor and furniture protection
Common questions about hearth extensions
What materials can a repaired hearth be finished in?
Noncombustible ones such as brick, stone, slate, concrete or tile, on a base suited to the fireplace. A factory-built unit's manual may add requirements for the layers beneath and for a clearly visible edge. Within those rules, the look is your choice.
Why do you tap on the hearth tiles during the visit?
A tile that is firmly stuck down sounds dull and solid, while one that has lost its bond sounds hollow. Hollow tiles are the next to crack or lift. Tapping the whole hearth shows how far the problem reaches before we price anything.
What does the written record say after a hearth repair?
It notes what was replaced on the surface, the work carried out beneath it, the materials used and their source, and any setting time still running. It also lists what we saw but did not touch.
More Ways to Care for Your Fireplace
- Chimney Flue RepairAssess repairs to damaged existing flue linings and distinguish them from a new liner installation.
- Ventless Gas Fireplace ServiceService the identified vent-free appliance without bypassing its required safety components.
- Chimney Flashing RepairRepair the chimney-to-roof connection with a scope that accounts for the adjoining roofing and masonry.
- Chimney Liner Installation and ReliningPlan a compatible chimney liner installation with the existing passage, connections and maintenance access considered together.
- Smoke Chamber RepairRepair identified smoke-chamber surfaces with the access and material requirements clearly defined.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo