Stone chimneys in Rio Vista, reset and repointed with care

Tell us which stones moved and where, and we will define the repair area with you.

Owned and run locally
Available for same-day service
Fully licensed and insured
Family owned and run

Call Now (645) 465-4171 Book Online

Joint and stone symptoms that point to water

Pieces of stone or mortar on the roof
Plants growing out of the joints
Loose stones above a door or walkway
A stone face pulling away from the wall

Jump to

What goes into a lasting stone repair

Mortar for manufactured stone

Manufactured stone is set and pointed with mortars its maker and the industry guide describe, including polymer-modified mortars for some surfaces. The right one depends on the backing, the product and the conditions on the day. Mortar that suits one backing can fail on another, which is why the surface matters as much as the stone.

We choose mortar for your stone and your surface, not a single mix for every job. Where the product is unknown, we choose conservatively and explain why. The estimate names the mortar type in plain words, and the written record confirms what was used.

The order of work on a stone repair

Water entry at the top or the roof junction is dealt with first. Then loose stones come off, the backing is repaired, and the drainage details at the base are restored where they have failed. Each step waits for the one before it to be sound.

Stones are reset next, joints are filled and tooled, and the mortar cures. Cleaning comes last, once the mortar is hard enough to handle it. The estimate shows that order and notes which steps depend on the weather, so the schedule makes sense before it starts.

When removal shows more damage

Once stones come off, the backing may turn out worse than it looked. If so, work pauses at the edge of the agreed area instead of pressing on. A backing that looked fine through one opening can be soft a little farther along, and only removal shows that.

We show you what we found, explain the choices and give the added price. You decide whether to extend the work or close the area as planned. No extra work happens on assumption, and the opened area stays protected while you decide.

Using the fireplace during stone work

Exterior stone repair does not usually affect the fireplace. The stone sits on the outside of the chimney or its enclosure, away from the flue and the firebox. If the chimney serves a gas appliance, the same care applies to its vent opening.

If the work reaches the top, the flue area or the inside of a framed chase, we tell you whether to hold off using the fireplace until that part is complete. We also keep mortar, dust and debris away from the chimney opening while we work above it.

Inside a stone chimney repair estimate

Agreed removal of loose or displaced stones
Replacement stones blended with the originals
Separate line for crown, cap or cover work
Unused brackets and fixings removed or sealed

Questions on veneer and natural stone

How do you tell natural stone from manufactured stone?

Weight, edges, the back of a loose piece and the way joints are laid all give clues. Manufactured stone is a cast product with its color concentrated near the face. We tell you what we believe you have and why.

What mortar do you use for repointing stone?

One chosen for the stone and the assembly. For natural stone, the mortar should not be harder than the stone. Manufactured stone follows its maker's guidance. We explain the choice rather than using one mix everywhere.

Why is water getting in behind the stone on my chimney?

Common routes include the top, open joints, the roof junction and a blocked drainage edge at the base. We check each one and, when the job calls for it, use a hose water test to confirm the route.

Proudly American

Local service. Careful repairs. A fireplace worth coming home to.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Chimney & Fireplace Brands We Work With

DuraVent
Olympia Chimney and Venting
Copperfield Chimney Supply
Rutland
Heatilator
Heat & Glo