
Chimney stone repair for homes in Upper Eastside
Original stones are kept wherever they are sound, so the repair blends with the chimney.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Stonework changes worth a closer look
- Pieces of stone or mortar on the roof
- A section of stone bulging outward
- Flaking layers on the face of a stone
- Plants growing out of the joints
Jump to
Stone, mortar and water, handled in order
Getting new joints to blend with old ones
New mortar is darker when wet and lightens as it cures. Judging a color match on the day it goes in can mislead. The sand in the mix drives most of the final color and texture.
Where joints will be visible, we prepare a small sample and judge it once it has dried. National Park Service guidance on repointing stresses matching color and texture as well as strength. You see the dried sample before the full repointing goes ahead, and you can ask for an adjustment.
Open joints in the upper courses
The joints nearest the top of a stone chimney take the most rain and wind. They are often the first to open, and water that enters there can run down through the chimney behind the stone face.
We give the upper joints close attention during the inspection. Repointing them is often one of the most useful repairs on a stone chimney. If the top above them sheds water poorly, we explain how that adds to the wear and list the top repair as a separate item.
Marking the repair area on the chimney
We mark the stones and joints to be repaired and describe the area in the estimate. That makes the finished work easy to check against what was agreed, face by face. Marking the area before work starts also avoids debate about which stones were included.
If you want repointing to stop at a corner, or to cover a whole face for a consistent look, say so. The extra area becomes its own item with its own price. The price then covers a defined area, and the written record shows where the work stopped.
Reset, replace or repoint
Most stone chimney repairs combine resetting, replacing and repointing. Resetting puts sound stones back in a proper bed. Replacing swaps broken or eroded stones for matched ones. Repointing renews worn joints. A single chimney can need all three in different places.
The balance depends on what we find. We explain why each stone or joint falls into one group or another, and the estimate lists them that way. You can then see where the work and the cost sit, and adjust the scope if you wish.
Stone repair scope for homes in Upper Eastside
- Resetting stones in a full mortar bed
- Tooling joints once the mortar firms up
- Unused brackets and fixings removed or sealed
- Final review of joints, edges and blend
What people ask about stone chimney repair
What if the backing behind the stone is damaged?
We stop and show you what we found. Backing repair, such as lath, scratch coat or framing work, is priced as its own item. The stone goes back once the surface behind it is sound again.
Do you need roof access to repair a stone chimney?
For most chimneys, yes. The top, the upper stones and the roof junction are reached from the roof. We protect the roof covering, plan safe access and tell you if any area cannot be reached.
Why did stones on my chimney come loose?
Common causes include poor mortar coverage behind the stones, water in the backing, corroded lath or ties, and movement. The stone that came off often shows which cause applies, so we look closely at its back.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo

