
Storm-damaged chimneys assessed and repaired in Bay Harbor Islands
Any chimney we leave open is covered before we go each evening, and storm debris is hauled away.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Storm damage signs on chimneys in Bay Harbor Islands
- Chase cover blown off the chase
- Loose bricks at the chimney top
- Chimney top leaning or out of line
- Roof covering torn around the chimney
Jump to
Wind damage repairs, part by part
What a temporary cover is for
A temporary cover keeps rain, leaves and animals out of an open flue or chase while the permanent part is made or ordered. It is fixed so it stays put in normal weather.
It is not a replacement cap or chase cover, and we say so on the estimate. Its purpose, how long it is meant to stay and how it will be removed are written down. While it is on, the fireplace stays unused. When the permanent repair goes on, the temporary cover comes off and is hauled away.
How we reach the chimney top safely
We reach the chimney top with ladders and fall protection suited to the roof. On a roof damaged by the storm, the route to the chimney is chosen to avoid weak or broken areas.
Safe access is part of the job, not an extra that appears later on the bill. If a roof is too damaged to work from, we explain the options for reaching the chimney another way. We do not take risks that would put people or the roof at further risk, and we tell you if the roof itself needs attention before we can start.
Letting soaked masonry dry before sealing
Masonry soaked by a storm needs time to dry before a water repellent goes on. One repellent maker notes that excess moisture keeps its product from soaking in and shortens its service life.
Repairs to cracks, joints and flashing come first, because a repellent does not fix defects. A water repellent, if it is part of the plan, goes on after the masonry has dried and the repairs have cured. Chimney waterproofing is a separate service with its own line on the estimate, and we explain when it would be worth doing.
Where a crown coating stops being enough
A coating made for chimney crowns can close fine cracks and slow water entry. It works on a crown that is sound, sloped and still attached to the chimney.
It cannot rebuild a crown that has broken into pieces, lost its edge or never had a slope. Coating over those problems only hides them for a while. We explain which case applies to your crown and why. If a new crown is the right repair, the coating is not offered as a cheaper substitute that would fail.
What the after-storm inspection checks
- Chimney top checked as a set
- Chase siding or stucco check
- Damper checked for water and debris
- Advice on fireplace use until repairs finish
Before you approve storm repairs
Why check the whole chimney top if only the cap came off?
Wind that lifts a cap often loosens other parts too. The crown, flashing, chase cover and top courses can be damaged without showing from the ground. Checking them together avoids a second leak after the next storm.
Is a factory-built chimney repaired differently after a storm?
Yes. A factory-built chimney is a listed system, so damaged pipe, storm collars, caps and chase-top parts are replaced with parts the manufacturer lists. The label on the fireplace or chimney helps us identify them.
Are storm repairs covered by a warranty?
Our workmanship warranty covers the repairs we carry out. If one of those repairs gives way, call us and we return to check it. Temporary covers are not permanent repairs, and we explain what they are meant to do.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo
