Storm-damaged chimneys assessed and repaired in Coral Terrace
Any chimney we leave open is covered before we go each evening, and storm debris is hauled away.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Clues that wind or water got in after a storm
- Chase cover blown off the chase
- Brick or mortar pieces in the yard
- New crack across the concrete crown
- Banging from the chimney top in gusts
Jump to
Putting a storm-damaged chimney right
Counter flashing pulled from its joint
Counter flashing is let into the masonry and laps down over the base flashing. Masonry guidance for chimneys describes this layered detail. When wind pulls it out of its cut, water gets behind both layers.
We check that the counter flashing is still seated and sealed along its full length. Loose sections are reset into the cut and sealed. Where the cut itself has broken out, the masonry around it is repaired first. The estimate shows the flashing and any masonry work as separate lines.
A chimney top that has shifted
If the top of the chimney looks out of line after a storm, treat it as unstable. Keep people, pets and vehicles away from the area below it, and do not use the fireplace.
We assess a shifted chimney from a safe position before anyone works on it. The plan may start with taking down loose masonry to a sound level. Permanent work then follows, rebuilding the top to meet the code's height and cap rules. We explain each stage before it starts.
Cracks in a stucco chimney after the storm
A stucco-finished chimney can crack when debris strikes it or when the structure beneath flexes in strong wind. Fine cracks let wind-driven rain into the wall.
We check the stucco surface, its edges and the joints around the top. Cracks are described by size and location, and we explain whether the stucco can be patched or needs more. If water has got behind the finish, we note where. The stucco repair is listed separately from any crown or cap work.
How long storm repairs take
A refastened cap or a temporary cover can often be done in one visit. Relaying top courses, casting a new crown or fitting a custom chase cover takes longer, and the weather has a say in the schedule.
We give you a realistic timeline with the estimate. Custom parts need to be measured and made. Mortar needs time to cure before a cap is fixed to it. If the work runs past one day, an open top is covered before we leave each day. We tell you when the fireplace can be used again.
How a storm damage estimate is laid out
- Chimney top checked as a set
- Crown surface and edge check
- Storm debris cleared from flue and firebox
- Workmanship warranty on completed repairs
Storm damage chimney questions in Coral Terrace
Is a factory-built chimney repaired differently after a storm?
Yes. A factory-built chimney is a listed system, so damaged pipe, storm collars, caps and chase-top parts are replaced with parts the manufacturer lists. The label on the fireplace or chimney helps us identify them.
Will a new chase cover look like the old one?
It is made to fit the chase and the chimney pipe, with a shape that sheds water, such as cross-breaks and a drip edge. It may look slightly different from a flat old cover, and we explain why before ordering it.
Can storm damage affect a chimney that vents a water heater?
Yes. A chimney can vent other appliances as well as a fireplace. If its top or flue was damaged, those appliances may not vent properly. Tell us what the chimney serves, and we check the flue that carries their exhaust.
More Ways to Care for Your Fireplace
- Chimney Flue RepairAssess repairs to damaged existing flue linings and distinguish them from a new liner installation.
- Spalling Brick Repair and Chimney Brick ReplacementReplace deteriorated chimney bricks while retaining suitable surrounding masonry.
- Chimney RebuildRebuild the affected chimney section with the retained structure, roof connection and passage included in the plan.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo