Storm-related chimney repair for Nurmi Isles homes
A blown-off cap or a lifted chase cover leaves the flue open to rain. We close it, then repair it properly.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Chimney changes to note after strong wind
- Loose bricks at the chimney top
- New crack across the concrete crown
- Chimney top leaning or out of line
- Leaves and twigs in the fireplace
Jump to
Storm damage work, explained in order
How chimney caps are held in place
Caps are held on in several ways. Some bolt onto the flue tile, some clamp around the brick with a band, some use brackets, and some multi-flue caps are screwed into the crown. Cap makers describe each method in their instructions.
After a storm, the fastening tells us why a cap moved. Bolts may have loosened, a band may have slipped or anchors may have pulled out of a cracked crown. We match the replacement or refastening to the cap type and the masonry it sits on.
Flashing torn or lifted at the roof line
Flashing seals the joint where the chimney meets the roof. Wind can lift its edges, tear it at the corners or pull it away from the masonry. Rain then runs behind it and into the house.
We check the base flashing on the roof and the counter flashing on the chimney above it. A section that has only lifted may be reset and sealed. Torn or badly bent flashing is replaced. The work is coordinated with the roof covering around it, which often needs attention too.
If a carbon monoxide alarm sounds after the storm
If a carbon monoxide alarm sounds, move everyone outside at once. From outside, call 911, and do not go back in until responders say the house is clear.
After a storm, a damaged cap, a debris-blocked flue or a cover over a working vent can push exhaust back into the house. Consumer safety guidance warns that vents and chimneys must stay clear of tarps and debris. Leave any fuel-burning appliance off until the flue has been checked and the cause found.
Letting soaked masonry dry before sealing
Masonry soaked by a storm needs time to dry before a water repellent goes on. One repellent maker notes that excess moisture keeps its product from soaking in and shortens its service life.
Repairs to cracks, joints and flashing come first, because a repellent does not fix defects. A water repellent, if it is part of the plan, goes on after the masonry has dried and the repairs have cured. Chimney waterproofing is a separate service with its own line on the estimate, and we explain when it would be worth doing.
Storm repair items, temporary and permanent
- Storm collar resealed to the flue pipe
- Loose top courses relaid
- Listed parts for factory-built chimneys
- Open chimney covered each work day
Questions about wind-damaged chimneys
The chase cover lifted in the wind. Can it be refastened?
Sometimes. If the metal is still flat and sound, it may be refastened and resealed. If it is bent, torn or rusted, a new cover shaped to shed water is the better repair. We explain which applies.
What if my roofer also needs to work around the chimney?
We coordinate so the flashing and the roof covering go in the right order. Roof covering work belongs to your roofer. Our estimate shows which chimney items we cover and where the two jobs meet.
What should I tell you when I call after a storm?
Describe what you see from the ground, what changed inside, such as water or debris in the fireplace, and when you noticed it. Mention whether the chimney is masonry or a metal flue in a framed chase.
More Ways to Care for Your Fireplace
- Firebox RepairRepair the damaged fireplace chamber using an approach suited to masonry or manufactured components.
- Spalling Brick Repair and Chimney Brick ReplacementReplace deteriorated chimney bricks while retaining suitable surrounding masonry.
- Fireplace Hearth RepairRepair the hearth surface after considering the supporting assembly and fireplace requirements.
- Chimney Cap Installation and ReplacementProtect the chimney opening with a cap chosen for its fit, attachment and compatible system.
- Chimney Masonry RepairRepair affected chimney brickwork and joints with materials selected for the construction already in place.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo