Fixing chimney stucco and its water source in Gladeview
We find out what sits behind the stucco before we patch it, so the repair suits the chimney.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When chimney stucco in Gladeview needs attention
- Cracks running through the stucco finish
- Hollow sound when the stucco is tapped
- Stains in the attic near the chimney
- Weep screed buried under soil or paving
Jump to
How we repair chimney stucco in Gladeview
Dampening block before new stucco goes on
Dry block or brick pulls water out of fresh stucco quickly. Plaster that loses its water too fast cannot cure properly and bonds poorly. Preservation guidance and the base coat maker both call for wetting a masonry base before application.
We dampen the prepared masonry so the surface is moist but not running with water, then apply the first coat. Metal lath is treated differently and is not soaked. The step takes little time, and it is one of the simplest ways to protect the bond of a chimney patch.
Loose stucco above a path or entry
Pieces of stucco that fall from a chimney can land on a walkway, a patio or a car. If you find fragments near the base, treat the area below as a place to keep clear.
Rope off or avoid the space under the loose section until it is assessed. Mention the location when you call, so we can look at it early in the visit. Where a quick temporary measure makes the area safer, we explain it and list it separately from the permanent repair.
Ledges and bands that collect water on stucco
Decorative bands, ledges and sills on a stucco chimney can hold water on their top surfaces. The International Masonry Institute advises protecting horizontal surfaces as part of stucco maintenance.
If a ledge is cracked or has lost its slope, water sits there and soaks in. We look at each horizontal surface on the chimney and note whether it sheds water. Where one needs rebuilding with a better fall, we describe how, and it appears as its own line. Small ledges are easy to overlook from the ground, so we check them up close.
The order of work on a stucco repair
A stucco repair follows a sequence, and each step depends on the one before. Water sources come first, then removal of loose plaster, then repair of the base, lath or barrier.
After that come the scratch coat, the leveling coat and the finish, each given time to cure. Paint, if it is part of the job, comes last. The estimate lists these steps in order, so you can see where each visit fits and why the work is spread out the way it is.
Stucco items written into your estimate
- Loose stucco area marked and measured
- Scratch coat keyed to the base
- Leveling coat brought to the wall plane
- Open top covered at each day's end
What people ask about chimney stucco
Why does the stucco near the ground keep breaking down?
The lowest part of the wall often stays wet from splashing rain, irrigation, soil piled against it or a buried weep screed. We check the base conditions and suggest changes you can make, alongside any repair we price.
Will you need to go into the attic?
Only if there is safe access and the chimney passes through it. The attic can show stains or damp sheathing that explain the outside damage. If you prefer we stay outside, tell us, and we note that the attic was not checked.
Do you replace the metal lath or reuse it?
Sound lath that has only pulled away can often be refastened. Corroded or torn lath in the repair area is cut out and replaced with corrosion-resistant lath lapped into what remains. The estimate says which we expect to do.
More Ways to Care for Your Fireplace
- Chimney WaterproofingTreat suitable chimney masonry after checking the surface, repair needs and product requirements.
- Wood-Burning Fireplace Insert InstallationFit a wood-burning insert after assessing its host fireplace and full connection requirements.
- Chimney TuckpointingRenew deteriorated mortar joints around chimney bricks that can appropriately remain.
- Chimney Masonry RepairRepair affected chimney brickwork and joints with materials selected for the construction already in place.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo