Stucco chimney repair in Roosevelt Gardens, coat by coat
Stucco repairs in Roosevelt Gardens come with a written record of the areas, materials and coats.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Signs chimney stucco is starting to fail
- White powder on the stucco surface
- Damp marks indoors beside the chimney
- Weep screed buried under soil or paving
- Vines rooted into chimney cracks
Jump to
What goes into a lasting stucco repair
The leveling coat under a stucco finish
The middle coat, often called the brown coat, builds the patch out to the plane of the surrounding wall. It carries more sand than the finish and does most of the work of making the repair flat.
If this coat stops short or sits proud, the finish cannot hide it, and the patch shows as a dip or a bump in low sunlight. We check the level against the old stucco around the repair before the finish goes on. That check is quick, and it saves a repair that only looks right from straight ahead.
Corrosion-resistant lath and fasteners by code
The Florida Building Code's exterior plaster section requires lath and its attachments to be corrosion-resistant. It also points to the ASTM standards for how lath is fastened and how plaster is applied.
When we replace lath in a repair area, the new lath and fasteners follow that requirement. We fasten the new lath into sound framing or backing and lap it with the lath that stays. The estimate names the lath and fastener type, so you can see what is going behind the finish.
Checking the old coating before adding a new one
A new coating has to bond to what is already on the wall. The International Masonry Institute recommends knowing the type of existing coating and testing how well it adheres before any recoating project.
For a chimney, that can mean a small test area and a check of whether the old coating lifts. If it does, it needs removing where it has failed. We tell you what the test shows and how it affects the scope, rather than coating over a surface that is already letting go.
Rust spots in rows on chimney stucco
Small rust spots arranged in rows can mark the heads of fasteners holding the lath. When water reaches them, they corrode and stain through the finish. The pattern often repeats across a face.
Spots like these suggest the lath fasteners are wet, which raises questions about the barrier and the water source. We note the pattern and whether the plaster around it sounds hollow. A repair may involve new fasteners and lath in that zone, not only a coat of stain-blocking paint.
Stucco repair scope for homes in Roosevelt Gardens
- Sounding survey of each accessible face
- Sealant at stucco transitions
- Exploratory opening with your approval
- Access by ladder, roof or scaffold
Questions about chimney stucco repair
Does rain affect when new stucco can be applied?
Yes. Heavy rain can damage fresh stucco, so we cover the work or move a coat to another day when rain threatens. Strong heat matters too. We tell you in advance if the forecast changes the schedule.
What does the free inspection include for a stucco chimney?
We look at every accessible face, tap for hollow areas, and check the top, the roof junction and the base. We explain what we saw and what we could not see. A free written estimate follows, with each item priced separately.
Do you clean up the dust and debris afterward?
Yes. We protect the ground and surrounding surfaces during the work and tidy the area each day. Old stucco, lath and other debris are cleaned up and hauled away when the job is finished.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo