Top sealing dampers chosen and fitted in Deerfield Beach

A top damper fitted to its maker's instructions and backed by our workmanship warranty.

Owned and run locally
Available for same-day service
Fully licensed and insured
Family owned and run

Top sealing damper choices explained

The adhesive that holds the frame

Many top dampers are held to the flue tile by a bead of high-temperature adhesive, pressed firmly and filled at any gaps. One maker's instructions insist on using only the adhesive supplied with the damper.

We follow the adhesive instructions that come with the product you choose. The tile top is cleaned first so the bead bonds to sound material rather than soot or old sealant. The estimate names the product and its fixing method, and the record notes what was used.

Confirming the closed lid from above

Once the cable and handle are set, someone goes back up to look at the lid in its closed position. The gasket should be pressed evenly all the way round, with no gap at the corners or the hinge side.

That step is in the maker's instructions for a reason. A damper that looks closed from the firebox can still leave a gap at the top. We check it with the handle locked, adjust if needed and check again. The record of the work notes that the seal was confirmed from above.

When an old top damper needs replacing

An old top damper may be past service if its frame has come loose or its hinge has broken. A distorted lid, or a model with no parts left, points the same way. At that point, replacement is usually simpler than repair.

Removing the old frame can take care, since the adhesive may be stubborn and the tile top can be damaged. We explain that before starting. If the tile needs repair after removal, we stop and show you. The new damper is then set on a sound top.

Checks once the damper is fitted

Before we leave, the damper is opened and closed several times from the handle. We watch the lid from the roof for a full opening and an even close. The bracket is tested for movement, and the cable is checked for rubbing along its route.

We also confirm that the old throat damper cannot swing into the smoke path. Anything that still concerns us goes into the written record. You should find the damper working as described the first time you use it.

Looked at during a free damper inspection

Product restrictions checked against the fireplace
Cap or screen above the damper
Seal checked from the roof
Old hardware and debris hauled away

Before you add a top damper in Deerfield Beach

Can I add a top damper if gas burns in the firebox?

Usually not with the common products. A vented decorative gas appliance needs the damper held fully open while it burns, and several top damper products are marked not for that use. We read both sets of instructions before giving you an answer.

Can you fit a top damper on a round or lined flue?

Often, yes. Makers offer adapters for round flue tiles, stainless liners and some factory-built chimneys. We confirm that the adapter and damper suit your flue, and that the chimney's own instructions allow it, before quoting.

How soon can I use the fireplace after installation?

The adhesive under the frame needs time to set before the fireplace is used. We tell you the maker's set time at handover and write it on the record, so the next fire waits until the seal is ready.

Proudly American

Family owned and operated in Miami, Florida.

Call Now (645) 465-4171

Book Your Free Inspection in Miami

(645) 465-4171

Chimney & Fireplace Brands We Work With

DuraVent
Olympia Chimney and Venting
Copperfield Chimney Supply
Rutland
Heatilator
Heat & Glo