Ventless gas logs, pilots and burners repaired in Boca Pointe
A clear diagnosis, a written estimate and work only on the items you approve.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
When a vent-free fireplace in Boca Pointe needs a look
- Igniter clicks with no flame
- Roaring or whistling from the burner
- Moisture on windows while it runs
- Uneven or delayed burner lighting
Jump to
Vent-free fireplace service, from pilot to room
Vent-free heat as a supplement, not the whole house
The state fuel gas code lets an unvented room heater add warmth to a home. It may not serve as the home's sole comfort heating. The manuals say the same in their own words and call these units supplemental. They are made to take the edge off a room, not to replace a heating system.
If the vent-free unit has become the main heat for the house, tell us. That changes how long it runs and how the room air behaves. We explain what the rules expect and service the unit for the job it was listed to do.
Construction dust in a ventless burner
Sanding, drywall work and demolition put fine dust in the air, and a vent-free burner draws that air through its pilot and ports. Dust that settles there changes the flame and can trip the sensor. It often shows up the next time the unit runs after the work.
If there was building work in the house, keep the unit off until the dust has settled and been cleaned. Tell us what was done and how close it came to the fireplace. We clean the pilot intakes, the ports and the air opening, then check the flame before you use it again.
Where vent-free logs may run only as vented
One log set manual notes that some codes allow its burner to run only in a vented mode, with the damper open. The code in force for your home governs that choice, not the maker's brochure. The installation should have been set up to match.
We check how your set is being run and what its manual allows. If the unit is running vent-free where only vented use is allowed, we explain that and what would need to change. Questions about how a rule applies can also go to your local building department.
A vent-free flame lower than it used to be
A flame that has grown smaller over time usually has a plain cause. The thermostat or remote may be set low, the burner orifice may be partly blocked, or the pressure reaching the burner may have dropped. Dirty ports can shorten the flame along part of the burner.
Tell us whether the change came slowly or all at once. We check the setting first, then the pressure and the gas path. If the burner is doing what the manual describes at that setting, we show you how to adjust it rather than replace anything.
What a ventless fireplace estimate lists
- Burner primary air opening cleaned
- Ceramic media level in the burner
- Drafts from fans and vents noted
- Written record of the work
Vent-free gas logs and pilots, answered
Is a vent-free unit meant to heat the whole house?
No. The Florida fuel gas code says unvented room heaters may not be the sole source of comfort heating in a home, and the manuals call them supplemental. They warm a room, with that room's air and volume in mind.
Should a working vent-free fireplace still get routine cleaning?
Yes. The manuals call for routine cleaning and inspection by a service person, including the burner ports, the air opening and the ODS pilot. Rooms with pets, carpet or heavy use may need it more often, and we suggest a pattern for yours.
Do drafts from a ceiling fan affect a vent-free burner?
They can. Manuals warn that drafts from fans, vents and returns alter the flame pattern and can cause soot or pilot outages. We watch the flame with the fan on and then off, so you can see the difference yourself.
More Ways to Care for Your Fireplace
- Spalling Brick Repair and Chimney Brick ReplacementReplace deteriorated chimney bricks while retaining suitable surrounding masonry.
- Chimney Sweep and Chimney CleaningArrange careful chimney cleaning in Miami with a defined scope, protected work area and useful findings.
- Top-Sealing Damper InstallationFit a top-mounted damper only after checking the fireplace, product restrictions and control route.
- Chimney RebuildRebuild the affected chimney section with the retained structure, roof connection and passage included in the plan.
- Fireplace Hearth RepairRepair the hearth surface after considering the supporting assembly and fireplace requirements.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo