
Vent-free fireplace service and repair in Highland Beach
Vent-free service that respects the safety pilot, the room size rules and the listing of the host fireplace.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
What changes in a ventless unit before a repair
- Igniter clicks with no flame
- No spark at the pilot
- Control knob stiff or stuck
- Smoke from logs after break-in
Jump to
Ventless fireplace repair, explained step by step
Pilot that dies when the gas knob is released
On a millivolt control, the pilot is held in by hand until the sensing tip warms. If the pilot dies the moment the knob is released, the thermocouple is not holding the valve open. The cause can be a dirty pilot, a weak flame, a loose connection at the valve or a worn part.
We check them in that order, because the simpler causes come first. Please do not hold the knob in longer than the manual says, or relight again and again. Leave the unit off and describe what happened when you phone us.
Room size against a vent-free input rating
Florida's fuel gas code limits how much unvented input a room may carry for its volume. The maker's manual turns that into a sizing guide for each model. A unit that is large for its room uses more of the room's air than the rules allow.
We compare the rating plate with the room and any spaces that open freely into it. This matters most when a larger unit replaced a smaller one. If the unit is oversized for the room, we explain what that means and what the choices are.
Vent-free heat as a supplement, not the whole house
The state fuel gas code lets an unvented room heater add warmth to a home. It may not serve as the home's sole comfort heating. The manuals say the same in their own words and call these units supplemental. They are made to take the edge off a room, not to replace a heating system.
If the vent-free unit has become the main heat for the house, tell us. That changes how long it runs and how the room air behaves. We explain what the rules expect and service the unit for the job it was listed to do.
Moving a vent-free log set to another fireplace
A vent-free set that worked in one fireplace is not automatically right for another. The new host must be listed for it, the room must suit its input and the clearances must match the manual. The connector route changes too.
Ask before moving a set between fireplaces or homes. We check the new setting against both manuals and the room rules in the fuel gas code. Moving and reconnecting the set is a separate item, and supply piping stays with a gas contractor.
The vent-free service scope in Highland Beach
- ODS pilot flame against the manual
- Control compartment cleaned
- Soot source traced and corrected
- Written record of the work
What people ask before a ventless repair
Can the burner run with the fireplace doors closed?
No. Log manuals require fireplace doors to be fully open whenever a vent-free burner operates. Closed doors can cause sooting and pilot outages, and one manual lists damage and injury among the risks. We explain the rule for your set.
Will you work on the gas piping that feeds the fireplace?
Supply piping belongs to a gas contractor or your gas utility. We check the appliance side, take pressure readings at the valve where it allows and tell you plainly if the supply is the problem, so the right trade handles it.
Do you service vent-free log sets as well as complete units?
Yes. We service self-contained vent-free fireplaces and vent-free log sets in existing fireplaces. For a log set, we also check the host fireplace, its damper and its clearances, because the listing covers the combination.
Proudly American
Local service. Careful repairs. A fireplace worth coming home to.
Call Now (645) 465-4171We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting Copperfield Chimney Supply 
Rutland Heatilator Heat & Glo

