Ventless gas logs, pilots and burners repaired in Imperial Point
If the room or the host fireplace is the real problem, we say so rather than selling you a part.
- Owned and run locally
- Available for same-day service
- Fully licensed and insured
- Family owned and run
Ventless fireplace warning signs in Imperial Point
- Igniter clicks with no flame
- Flames orange, stringy or lazy
- Moisture on windows while it runs
- Smoke from logs after break-in
Jump to
How we service a ventless gas fireplace in Imperial Point
Lint, pet hair and webs at the pilot intakes
The pilot on a vent-free burner draws room air through small openings. Carpet fibers, bedding lint, pet hair and spider webs collect there quietly. As the openings narrow, the flame starves and the sensor can shut the unit down with nothing else wrong.
Tell us if the room has pets, deep carpet or a bed nearby, or if the unit sat unused for a long time. Those details point us toward the intakes early. Cleaning them is part of a routine visit, and we show you where they are.
Replacing an ODS pilot with the same model
When cleaning does not restore a steady pilot, the assembly is replaced. One maker states that a failed oxygen depletion sensor pilot should be replaced with the same model. Pilots that look alike can still react to air at different points.
We order the pilot listed for your burner and fuel, fit it as the manual shows and leak check every joint. Then the unit runs while we watch the pilot and the main flame. The written record notes the part fitted, so later service can confirm it.
Letting a vent-free unit cool before service
Burners, logs, glass and screens stay hot for a while after a vent-free unit shuts off. The manuals ask that service and cleaning wait until everything is cool. If you have been running the unit before the visit, turn it off early so the wait is short.
Cooling also lets us see the pilot and ports as they are, without disturbing fresh soot. We use that time to read the rating plate, find the manual and talk through what you have noticed since the problem began.
The codes behind vent-free gas service
Vent-free service draws on the fuel gas volume of the Florida Building Code, the fireplace chapter of its residential volume and the maker's manual. The appliance standard behind the listing sits under all three. None of them is a matter of taste.
We work from those documents on every visit in Imperial Point. When a question depends on how a code section applies to your home, we explain what the section says. Where a building official has the final word, we tell you that too.
Ventless gas fireplace work, item by item
- Burner primary air opening cleaned
- Burner ports cleared and inspected
- Main burner orifice size and condition
- Log positions reset to the diagram
Asked about ventless fireplace repair in Imperial Point
Is a vent-free unit meant to heat the whole house?
No. The Florida fuel gas code says unvented room heaters may not be the sole source of comfort heating in a home, and the manuals call them supplemental. They warm a room, with that room's air and volume in mind.
What happens during a free inspection of a ventless unit in Imperial Point?
We identify the model from its rating plate, look at the pilot, burner, logs and room, and explain what we found. You receive a written estimate with each item separate, and nothing is done until you approve it.
What should happen if a carbon monoxide alarm sounds?
Get everyone out into fresh air right away and call 911 from outside. Do not go back in until responders say it is safe. Keep the vent-free unit out of use until someone has looked at it and the reason for the alarm is known.
We received your request
Our team will contact you to arrange your inspection.
Chimney & Fireplace Brands We Work With
DuraVent 
Olympia Chimney and Venting 
Copperfield Chimney Supply 
Rutland 
Heatilator 
Heat & Glo